NIGHTSTICK XPR-5580G Viribus Intrinsically Safe Rechargeable Dual-Light Lantern Instruction Manual
- June 5, 2024
- NIGHTSTICK
Table of Contents
NIGHTSTICK XPR-5580G Viribus Intrinsically Safe Rechargeable Dual-Light
Lantern
WARNINGS
- Warning: To prevent ignition of a hazardous atmosphere, do not locate the charger for this product in the hazardous environment. The charger for this product must be located in an area known to be non-hazardous ONLY.
- Warning: To prevent ignition of a hazardous atmosphere, do not attempt to charge this product in the hazardous environment. This task must ONLY be performed in an area known to be non-hazardous.
- Warning: Lithium-ion batteries must be used and charged properly. Improper use can result in serious injury, fire, or death.
- Warning: Use only the included and approved 5500-BATT rechargeable battery pack from Bayco Products.
- Warning: Do NOT attempt to use any other rechargeable or non-rechargeable batteries with this light.
- Warning: To prevent ignition of a hazardous atmosphere, do not open the lens bezel in the hazardous environment. This task must ONLY be performed in an area known to be non-hazardous.
- Warning: When exchanging the rechargeable battery pack, use only the approved 5500-BATT rechargeable battery pack from Bayco Products.
- Warning: To prevent ignition of a hazardous atmosphere, the rechargeable battery pack must only be exchanged in an area known to be non-hazardous.
- Warning: Do not expose the rechargeable battery pack to water or salt water, or allow the battery pack to get wet.
- Warning: Do not store the rechargeable battery pack with metallic objects that may cause a short circuit.
- Warning: Substitution of components may impair intrinsic safety.
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
- For personal safety, always confirm the rating of any known hazardous or potentially hazardous location where the light is to be used.
INITIAL USE
Warning: To prevent ignition of a hazardous atmosphere, do not attempt to
charge this product in the hazardous environment. This task must ONLY be
performed in an area known to be non-hazardous.
Fully charge the XPR-5580 before the first use, or if the battery is new or
has been unused for several months. The maximum charge time required is
approximately 6 hours.
DAILY USE
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT ATTEMPT TO
CHARGE THIS PRODUCT IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST ONLY BE
PERFORMED IN AN AREA KNOWN TO BE NON-HAZARDOUS.
CHARGER INPUT: 12 VDC Max
- Use only the supplied Nightstick charger, 5500-BATT rechargeable battery pack and AC or DC adapter. For best performance, charge the 5580 when the flashlight beam starts to dim.
- Connect the AC power adapter to the charger. The LED indicator will not be illuminated at this point.
- With the flashlight facing forward, slide the 5580 into the charger until the contacts snap into place.
- The LED indicator changes to constant red indicating the 5580 is properly inserted into the charger and is in fact charging. The LED indicator remains red until the battery is fully charged. At full charge, the LED indicator turns green.
- The total time to full charge the 5580 varies depending on the remaining charge in the battery pack.
- To confirm a full charge, keep the 5580 in the charger and turn it on. The LED indicator will change to red. Turn off the 5580. If the 5580 is fully charged, the LED indicator will turn green. If not, it remains red until the charge is completed and the LED indicator turns green. The 5580 will now be fully charged.
REPLACING LITHIUM-ION RECHARGEABLE BATTERY
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT OPEN THE
LENS BEZEL IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST ONLY BE PERFORMED IN
AN AREA KNOWN TO BE NON-HAZARDOUS.
WARNING: WHEN EXCHANGING THE RECHARGEABLE BATTERY PACK, USE ONLY THE
APPROVED 5500-BATT RECHARGEABLE BATTERY PACK FROM BAYCO PRODUCTS.
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE RECHARGEABLE
BATTERY PACK MUST ONLY BE EXCHANGED IN AN AREA KNOWN TO BE NON-HAZARDOUS.
- Carefully loosen the center plug located on the rear side of the light with a flat head screw driver or small coin in a counter-clockwise direction.
- Slowly turn the light upside down and carefully shake the light in order to allow the 5500-BATT rechargeable battery pack to slide out of the light paying close attention to the battery pack’s orientation within the housing.
- Using only the approved replacement 5500-BATT rechargeable battery pack from Bayco Products, slide the new battery pack into the housing of the light using the directional arrow marked on the side of the pack to be a guide to proper battery orientation.
- Carefully tighten the plug with a flat head screw driver or small coin until it is fully seated. CAUTION: Do NOT overtighten the plug. Doing so may damage the threads and impair the light’s ability to properly charge and impact the light’s Intrinsic Safety.
OPERATION
The XPR-5580 has ten lighting modes: y High brightness flashlight
- Medium brightness flashlight
- Low brightness flashlight
- High brightness floodlight
- Medium brightness floodlight,
- Survival mode
- Blinking floodlight
- Dual-light
- Constant-on rear green light y Blinking rear-facing light
The XPR-5580 has two body switches providing access to all modes.
Constant-on Flashlight
Press the left switch forward for a high-brightness flashlight. Press the
switch forward again to turn the light off.
Select Brightness Level
Press and hold the left switch forward. The flashlight will cycle from high to
medium to low mode and then back up again at a rate of approximately one mode
per second. The light will continue to cycle up and down through the various
modes as long as the left switch is held down. When the desired brightness
level is reached, release the left switch and the light will remain in that
brightness mode. Press the left switch forward again to turn the light off.
Rear-Facing Lights
Press the left switch back to turn on the rear-facing green lights. Press the
switch back again to turn the lights off. Press and hold the left switch back
to activate the rear-facing beacon lights.
Constant-on Floodlight
Press the right switch forward for high brightness floodlight. Press the
switch forward again to turn the light off.
Select Brightness Level
Press and hold the right switch forward. The floodlight will cycle from high
to medium to survival mode and then back up again at a rate of approximately
one mode per second. The light will continue to cycle through the modes as
long as the right switch is held down. When the desired brightness level is
reached, release the left switch, and the light will remain in that brightness
mode. Press the right switch forward again to turn the light off.
Floodlight Beacon
Press the right switch backward for floodlight beacon. Press the switch
backward again to turn the floodlight beacon off.
Dual-Light
Dual-Light allows the user to turn on both the Flashlight (at any brightness
level) and the Floodlight (at any brightness level), at the same time. First
select the appropriate brightness level of the flashlight using the directions
above. Next select the appropriate brightness level of the floodlight using
the directions above. Both the Flashlight and the Floodlight are now running.
Press and release both the left and right switches forward to turn the lights
off.
WARRANTY
LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in
workmanship and materials for the original purchaser’s lifetime. The Limited
Lifetime Warranty includes the LEDs, housing and lenses. Rechargeable
batteries, chargers, switches, electronics and included accessories are
warranted for a period of two years with proof of purchase. Normal wear and
failures which are caused by accidents, misuse, abuse, faulty installation and
lightning damage are excluded. We will repair or replace this product should
we determine it to be defective. This is the only warranty, expressed or
implied, including any warranty of merchantability or fitness for a particular
purpose. For a complete copy of the warranty, go to www.baycoproducts.com
/bayco-product-support/warranties. Retain your receipt for proof of purchase.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>