NETUM PDA-7100 Enterprise Digital Assistant User Guide

NETUM PDA-7100 Enterprise Digital Assistant

Open the box

Please verify that your carton contains the following items:

• Mobile computer (terminal)
• USB charge/communication cable
• Power adapter with regional plug adapters
•  Battery
•  Quick Start Guide

If you order the accessories for your terminal, verify that they are also included with the order. Be sure to keep the original packing in case you need to return the terminal for service.

Getting to Know

Replacing battery

1. Turn off the terminal
2. Slide the lock in the direction shown
3. Lift the battery cover from the position shown.
4. Open the battery cover and take out the battery in the direction shown.
5. Slide the lock in the direction shown in the figure to fasten the battery cover.

Installing communication card/Replacing memory card

Terminal use the built-in storage ROM to store files and application data. The user can expand the storage capacity of the terminal by installing the memory card. Recommends the use of Single Level Cell (SLC) industrial-grade micro SD or micro SDHC memory card with terminals for maximum performance and durability. Contact with sales to select the qualified memory card. Note: before memory card is installed, micro SD / SDHC card should be formatted in Fat32 format.
Installing SIM card/Replacing memory card

1. Turn off the terminal.
2. As shown below, open and remove the SIM/micro SD card cover.

Charging Terminal

Terminal is shipped with the battery which has significantly high discharged power (>4000mAh). Charge the battery with a wall adapter for minimum 3.5 hours.
Note: Using terminal while charging the battery will significantly increase the time required to reach a full charge.

Warning： We recommend use the charging devices, its model is A8A-0502004-CN1. Use of any charger may damage, that is not covered by the warranty.
Warning： Ensure all components are dry, before mating terminals with peripheral devices. Mating wet components may damage, that is not covered by the warranty.

Turning Power On/ Off

To turn the terminal on, press the Power button for about 3 seconds.

Turning the terminal off

To turn the terminal on, press the Power button Turning the terminal off

1. To turn the terminal on, press the Power button
2. Touch Power off.

Forcing restart
When terminal doesn’t work, or crash, can press the power button about 10 seconds to force restart.

Using the Scan / Image Engine Demo

1. Touch scanner on desktop.

2. Point the terminal at the bar code.
   Note: For optimum performance, avoid reflections by scanning the bar code at a slight angle.

3. Touch and hold scan or press and hold the scan button. Aimer beam should be located on the target bar code. Note: The left and right side buttons also trigger the scan/imager.

4. The decode results display on the screen.

Aiming Beam

The aiming beam or pattern is smaller when the terminal is closer to the code and larger when it is farther from the code.Symbologies with smaller bars or elements (mil size) should be read closer to the unit.Symbologies with larger bars or elements (mil size) should be read farther from the unit.

Aiming at the beam diagram Linear Bar

Contact Information

Tel.: +0086 20-6626-0708
Whatsapp: +86 188 2626 1132
Email: service@netum.net
Addr.: Unit 137, the Pacific Industry Park, Xintang Town, Zengcheng District, Guangzhou, China/511340 Website: https://www.netum.net/
Name: APEX CE SPECIALISTS LIMITED
Add: UNIT 3D NORTH POINT HOUSE,NORTH POINT BUSINESSPARK, NEW MALLOW ROAD,CORK，T23 AT2P， IRELAND
Contact: Wells
Tel: +353212066339

References

• ce.com
• NETUM | Barcode Scanner | Thermal Printer | PDA Terminal Device

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>