Zibojingxiandianzishangwuyouxiangongsi JX-L01-BL Charging Station for Apple Instruction Manual
- June 5, 2024
- Zibojingxiandianzishangwuyouxiangongsi
Table of Contents
Zibojingxiandianzishangwuyouxiangongsi JX-L01-BL Charging Station for
Apple 
PART LIST
INSTRUCTION MANUAL
- Flip-up the folding phone supporting part.
- Find a suitable and stable charging angle for your phone, then align the phone and insert. Press the red area to make the phone “lightning port stand upright
- Stand the watch charger upright to charge. Put your watch on the watch charger holder
- Press the red area to make the AirPods lightning” port stand upright.Put your Airpods on the AirPods charger holder.
WARM TIPS
- The phone can be placed horizontally on the stand. The maximum upright angle is 90 degrees. Force may break the stand.
- The maximum upright angle is 90 degrees. Force may break the stand.
- Reach us by your Amazon order detail page (select “order” “sold by” or “contact seller”) for a warranty about it. order”
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of device, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.