HAMRON 619622 Tyre Tread Tester Instruction Manual
- June 6, 2024
- HAMRON
Table of Contents
HAMRON 619622 Tyre Tread Tester
SAFETY INSTRUCTIONS
Read the user instructions carefully before use.
Save them for future reference.
TECHNICAL DATA
| Measurement range | 0-25.4mm |
|---|---|
| Precision | 0.07 mm |
| Working temperature | 0-40°C |
| Battery | LR44, 1.5 V |
DESCRIPTION
- Bar
- Battery compartment
- Reset
- Power switch On/Off
- Base
- Tip
- Measurement unit
USE
- Insert the battery in the battery compartment (2). Make sure that+ is pointing up.
- Press the power switch.
- Select the unit of measurement: mm/tum (7).
- Apply (5) on flat surface and press down the bar (7).
- Reset(3).
- Apply (5) against the tyre. Hold it firmly and press the tip (6) into the tread.
- Check the reading.
- Switch off (4).
MAINTENANCE
- Keep the bar clean.
- Make sure that there is no dirt, water or oil on the bar.
- Remove the battery if the tyre tread gauge is not going to be used again for a while.
- The display starts flashing when it’s time to change the battery.
- If the display shows an error, remove the battery and replace after 30 seconds.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>