HAMRON 005076 LED Flashlight Bar Instruction Manual
- June 6, 2024
- HAMRON
Table of Contents
005076
FLASHLIGHT BAR LED
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions).
SAFETY INSTRUCTIONS
- Complies with ECE R65 (EMC),
- Never look directly into the flashlight – risk of eye injury.
TECHNICAL DATA
| Light source | 32 x SMD LED |
|---|---|
| Rated voltage | 12/24 V DC |
| Flashing per minute | 60/105 |
| No. of flashing patterns | 26 |
| Application temperature | -30 – 60 °C |
| Safety class | IP67 |
| Magnetic base | Yes |
| Cord length | 3 m |
| Dimensions | 200 x 180 x 30 mm |
DESCRIPTION
- Power switch (Off/On)
- Flashing pattern selector button
FIG. 1
FLASHING PATTERN
- Single (R65)
- Double (R65)
- Half/half
- Crosswise flashing
- Clockwise rotation
- Anti-clockwise rotation
- Allthalf
- All-single—fast
- Triple
- ‘Fivefold
- 8 flashing
- 12 flashing
- Clockwise constant flashing
- Anti-clockwise constant flashing
- Clockwise single
- Anti-clockwise single
- Clockwise rotation
- Anti-clockwise rotation
- Anti-clockwise—clockwise
- Middle—side
- Single switching
- Triple switching
- Fivefold switching
- Half fixed, half single
- Half fixed, half single
- Constant
USE
The base is magnetic and attaches to all magnetic surfaces. For mounting on vehicles, where there is a risk of the flashlight ramp loosening, it is recommended that the unit is screwed in position instead (screws sold separately).
CONNECTION WITH 12/24 V CONNECTOR
Starting/switching off
Connects to the vehicle’s cigarette lighter socket. Press the power switch on
the 12/24 V connector to turn the flashlight ramp on and off.
Flashing pattern
Switch between 26 different flashing patterns. Press the flashing pattern
button for a maximum of one second to select the next flashing pattern. Repeat
the procedure until the required flashing pattern starts. If the button Is
press and held for three to five seconds the previous flashing pattern starts.
If the button Is pressed and held for more than five seconds the unit switches
off. When started the last selected pattern Is active.
CONNECTION THROUGH FIXED INSTALLATION
Connect the wires as follows:
- RED: +VDC
- BLACK Earth
- YELLOW: Selection of flashing pattern
Switch between 26 different flashing patterns by creating contact between the yellow and black wires for ma. one second. Repeat the procedure until the required flashing pattern Starts. If the wires are connected for three to five seconds instead the previous flashing pattern starts. Contact longer more than five seconds switches the unit off. When started the last selected pattern is active.
Care for the environment!
Recycle discarded product in accordance with local regulations.
Jula reserves the right to make changes. For latest version of operating
instructions, see www,jula.com
JULA AB, BOX 363, SE-532 24 SKARA 2022-01-04
© Jula AB