Hamron 016019 Light Bar LED Instruction Manual

Hamron 016019 Light Bar LED

SAFETY INSTRUCTIONS

• Read these instructions carefully before installation and save them for future reference.
• Always comply with the applicable laws and regulations for the installation and use of auxiliary headlights.

SYMBOLS

• Read the instructions.
• Approved in accordance with the relevant directives.
• Recycle discarded products in accordance with local regulations.

TECHNICAL DATA

TECHNICAL DATA

Rated voltage| 9-36 VDC
Light source| 54 x 5W LED
Output| 270W
Luminous flux| 24300 Im
Colour temperature| 6000 K
Range| 1 lux at 673 m
Range| 0.25 lux at 1346 m
Protection rating| IP68
Cord length| 50 cm
E-approved| Yes
ETM*| Yes

Size                W765 x H58.5 x D52.5 mm Weight                       2.75 kg

• Electronic thermal management

DESCRIPTION

Powerful extra lighting that makes driving safer and less tiring. Harmon’s powerful light bar has double rows of ultra bright LED light sources. This produces a wider and more powerful beam. There are a total of 54 x 5 W LED
light sources that deliver 24300 theoretical lumens and 20655 actual lumen. The beam is a so-called Combo beam, which means that the light bar produces a beam a long way ahead on the road, while diffuse reflectors on the sides create a wide and uniform beam to provide light on the sides of the road. LED light sources have electronic thermal monitoring
(ETM), which retains the intensity of the diodes and avoids discoloring if the heat becomes excessive. Adapted for fixed installation and mounted on the supplied side fasteners made of stainless steel. Installation accessories and DT connector included.  FIG. 1

ETM

Thanks to Electronic Thermal Management (ETM) the intensity of the diodes is maintained and discoloring is avoided if the heat becomes excessive.

INSTALLATION

1. Disconnect the negative/chassis earth cable from the battery before connecting the product, to avoid damage from short­circuiting during the installation.
2. Follow as far as possible the existing cable routing for installation of new cables. Carefully fasten the cable and any excess length with cable ties, insulating tape or the equivalent. Cable grommets through the firewall should be at a safe distance from moving parts.
3. Drill screw holes with a diameter of 8.5 mm in the surface where the product is to be installed.
4. The product can be mounted with side (1) or bottom (2) fasteners. Put the screws in the holes, put on the lock washers and tighten the nuts.

Cable colour coding

The DT connector’s red wire is(+) and the black wire is(-). Using the white wire together with the red and black wire produces half power as per ECE R112.

• red + black wire = terrain mode
• red + black+ white wire= ECE R112 approved mode.

WARNING

• The product must only be used within its rated voltage range, 9 to 36 VDC.
• The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
• Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>