Adexa R Series Commercial Coffee Brewer Instruction Manual

Adexa R Series Commercial Coffee Brewer

INTRODUCTION:

We are really pleased that you have chosen our high quality product of Automatic Coffee Machine, and we are very sure that you have made a correct decision. Before your use it, please read the following instructions carefully.

WARNING:
The following warnings and precautions must be observed.

• Never immerse the machine in the water. If the machine has been soaked, it must be dried and checked by specialist before using it again.
• Never pour hot water into the Water Reservoir.
• Never pour more than 2.2 liter of water into the Water Reservoir
• When working, the unit has to be placed in a horizontal position.
• Unit only suitable for indoor and countertop to use.
• Before installation, you should confirm the rating plate on the machine is suitable for your electric outlet.
• When the machine is in use, some parts of the machine are very hot. Ensure the power cord does not touch the hot parts. The use should also be careful not to touch the hot parts.
• Remain in the vicinity of the machine while machine is in operation.
• Don’t disconnect appliance with wet hands and Don’t pull the supply cord.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• Please stop to use unit when power cord damaged, the power cord should be replaced by qualified person with specified type, please contact with the service agent or the Sales Rep. of distributor.
• In the following pages, all the important items are marked by attention. to attract your
• Disclaimer: The Manufacturer will accept no liability for any injury or damage caused by incorrect usage of the machine or by improper operation contrary to information given in this Instruction Manual.

MODEL DESIGNATION:

Notice: The * in the model number is different nameplate designs. The three digits suffix is the refer code; both of them are not impact to any specifications, function or usage of the machine.

SPECIFICATION:

DIMENSIONS:

ACCESSORIES:

The following accessories may purchase separately for different models:

RECOGNIZE:

1. Switch of the Extra Warmer on top.
2. On/off Switch with Indicator
3. Water tank inlet.
4. Extra Warming Plate
5. Filter Pan with Ring Spring
6. Machine Body. (Earthing terminal)
7. Power cable with plug
8. Warming Plate on base.
9. Decanter (or Thermos)
10. “Brewing” Indicator (Green.)
11. “Warning” indicator (Red)

• The Ring Spring must always wedge well on the bottom of Filter Pan. Otherwise coffee will overflow from the Filter Pan.
• The spring may loss its elastic after used for awhile. To expand it little bit, than it can be resume again.

INSTALLATION:

1. Place the Machine on a firm and horizontal table.
2. Wedge the Spring well and Slide the Filter Pan into position of machine.
3. Pour of cold water (no more then 2.2 liter) into the Water Reservoir, wait for 1 minute for water to force the air out of the Machine.
4. Place an empty Glass Decanter, Vacuum Pot or Thermos at correct position under the Filter Pan.
5. Turn the Switch ON and the “Brewing” Indicator lights up.
6. HOT WATER starts to flow into Glass Decanter, Vacuum Pot or Thermos.
7. 4~5 minutes later, the “Brewing” Indicator will turn off; the brewing process has ended.
8. You should repeat the above process 2 to 3 times to clean the internal parts of The Machine before brewing coffee for first time.
9. During above operation, it is normal to hear some hissing and biilizy sound of water and to see some water vapor coming out.

OPERATION:

1. Assembly the Filter Pan and put appropriate amount of coffee on a Filter Paper.
2. Slide the Filter Pan into position.
3. Pour a pot of cool water into the water tank.
4. Place an empty Decanter or Pots at the correct position under Filter Pan.
5. Switch the power ON, the “Brewing” Indicator lights up; a process of brewing has begun.
6. Coffee start flows into the Decanter or Pots.
7. When “Brewing” Indicator lights turn off, there is no more coffee flows out from the unit; a brewing cycle has completed.
8. The warmer on the base will continue to heat up, until the user turn the switch off.
9. For the unit without warmers, please turn power OFF, and lock the cap of Pot or Thermos. A pot of coffee can now be served.
10. Although the machine has an overflow pipe in the Reservoir, just in case the amount of water in Reservoir exceeds; the user still should be careful not let the water exceeds 2.2 liter in order to avoid over flow.
11. Since there is always some remaining water in the hoses or boiler of the Machine; if the Machine will not be used for some time, or if the Machine needs to be removed, please pour out the remaining water and clean it before storage.
12. When the Machine is to be used again after a long period, please repeat steps of Installation.
13. If the Machine is not to be used for a short time, please clean the Machine with fresh water before using again.
14. When the Warning indicator lights up, it reminds the user to de-scale in time.

• Caution! Remove the Brew Chamber carefully and slowly when it hot!
• Caution! Hot Surface!
• DO NOT keep EMPTY decanter on Warming Plate.

MAINTENANCE:

Cleaning
It is important for the Machine and its accessories be kept clean after using.

•  Unplug the coffee maker and allow to cool,
• Wipe all external surfaces including the hotplate with a damp cloth and dry thoroughly.
•  The glass jug, pots and filter basket should be washed in warm soapy water than rinse and dry all parts thoroughly.
  No parts are suitable for cleaning in a dishwasher. Never use harsh or abrasive cleaners.

De-sediments
If you operate in a hard water area, we recommend to de-scaling at regular intervals, e.g. every 2-3 months or as required. If the brewing cycle takes time longer than usual, or the steam condition is bigger than normally, it is a signal that de-scale is necessary.

• Add 300 ml fresh lemon juice or condensed lemon juice to 1 liter of warm water (below 50°C).
• Slide Filter Pan and Place an empty decanter or receptacles at the correct position under the Filter Pan.
• Pour solution of lemon juice into Water Reservoir and Turn the switch ON.
• Some of hot water will drop into the decanter or receptacles until the solution of lemon juice push out the waters remained in the Machine. When there are some solutions of lemon juice drop into the decanter or receptacles, then turn the switch OFF.
• Wait for 5~6 minutes to enable the rest of solution to run through with sediments, then turn the switch ON again.
• When the indicator lights off, set switch OFF and flush the solution away.
• Since some solution will still remain in the Machine, we must run brewing process several times, until there is no more smell of lemon juice in the hot water which flow out from the Machine.
• The machine is ready for server again.

Re-setting
In case, if the brew cycle fails to operate switch the appliance off and unplug from the power supply. Remove the rear cover and check to see if you can press the button down on the side of the boiler. If the button presses down and clicks, then descale the unit before next operation. If problem persists, then contact the Helpline.

Pour out water remained inside of machine before stock or remove.

Detailed Operating Instructions

Model #:RUG2201

• Volt : 220~220Vac, 50~60Hz
• Wattage : 1885-2243w

RU/RB series coffee maker

• Volt: 220~240Vac, 50~60Hz
• Capacity: 24 Cups.

1. Water tank
2. Function indicator
3. Filter Basket
4. Hot Plate on base
5. Switch for Hot Plate on top
6. Switch for Brewing & Base Hot Plate 7, Extra Hot plate on top
7. Decanter/ thermos/air pot

Read the instructions before using the appliance.

CAUTION! HOT SURFACE!
CAUTION! Read the instructions before using the appliance.

• This appliance is suitable for commercial use.
• Remain in the vicinity of the machine while machine is in operation.
• Never immerse the machine in the water. If the machine has been soaked, it must be dried and checked by specialist before using it again.
• Never pour hot water into the Water Reservoir.
• Never pour more than 2.2 liter of water into the Water Reservoir
• Do not disconnect appliance with wet hands and do not pull the supply cord.
• Only replace the supply cord with the type specified the instructions. Contact the manufacturer, service agent or similar qualified person for further advice.
• When the machine is in use, some parts of the machine are very hot. Ensure the line cord does not touch the hot parts. The use should also be careful not to touch the hot parts.

Installation:

1. Place the Machine on a firm and horizontal table.

2. Slide the Filter Pan into position.

3. Pour of cold water (no more then 2.2 liter) into the Water Reservoir, wait for 2 minute for water to force the air out of the Machine.

4. Place an empty Glass Decanter at correct position under the Filter Pan.

5. Turn the Switch ON and the “In Use” Indicator lights up.

6. Some of HOT WATER starts to flow into Glass Decanter.

7. 5~6 minutes later, the ” Indicator ” will off The brewing process has ended.

8. You should repeat the above process 2 to 3 times to clean the internal parts of the machine before brewing coffee for first time.

9. During above operation, it is normal to hear some hissing and biilizy sound of water and to see some water vapor coming out.
   Operation:

10.  Slide the Filter Pan into position.

11. Pour a decanter of cool water into the Water Reservoir.

12. Place the empty Glass Decanter at the correct position under Filter Pan.

13. Switch the power ON, the “Indicator” will light up.

14. Coffee will start to flow into the Decanter.

15. When the “Indicator” light turns off, the brewing cycle has completed.

16. Since there will always be some water remaining in the hoses, the boiler etc. of the Machine. If the Machine will not be used for some time, or if the Machine should be removed, you should always pour out the remaining water in the Machine, and clean it for storage.

Incase, if the thermostat reaction causing the lime build up, user must to presses down and clicks, then descale the unit before next operation, and the descale process as below. If problem persists then contact the Helpline to descale, we recommend you use an appropriate

De-scale
On areas in the water boiler, hard water will cause chalk and limestone will to accumulate when machine is used. To keep the Machine in the best condition and ensure each coffee brewing resulted in the best taste, we recommend that of the Machine has successive brewed for 200 time used for 6 months, a De-scale operation be carried out as the following:

• Add 300 ml fresh lemon juice or condensed lemon juice to 1 liter of water.
• Slide Filter Pan into position.
• Place an empty Decanter at the correct position under the Filter Pan.
• Pour the lemon juice solution into the Water Reservoir.
• Turn the switch ON.
• Some of hot water will drop into the jug, Until the solution of lemon juice push out the water remained inside of the Machine and there is some solution of lemon juice start to drop into the jug, than turn the switch OFF.
• Wait for 5~6 minutes to enable the rest of solution to run through with sediments, than turn the switch ON again.
• When solution of lemon juice is no longer dripping out, set switch OFF and flush the solution away.
• Since some of lemon juice solution will be remain in the Machine, please run the brewing process several times until there is no more taste and smell of lemon juice in the hot water flow out from the Machine.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>