PHILIPS PATPA Antumbra Touch User Interface Instruction Manual
- June 9, 2024
- Philips
Table of Contents
PHILIPS PATPA Antumbra Touch User Interface
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
Installation Instructions
FCC
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency
Notice – This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help. Any modifications not approved by the
manufacturer of this device could void the user’s authority to operate this
device.
This Class B digital apparatus complies with Canadian ICES-003: CAN
ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la
norme NMB-003 du Canada: CAN ICES-3(B)/NMB-3(B).
Installation of a home and building automation and control system shall comply
with IEC 60364 (all parts). The temperature limits and current-carrying
capacities for the communication wires specified in IEC 60364-5-52 shall not
be exceeded. © 2022 Signify Holding. All rights reserved. Specifications are
subject to change without notice. No representation or warranty as to the
accuracy or completeness of the information included herein is given and any
liability for any action in reliance thereon is disclaimed. Philips and the
Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
All other trademarks are owned by Signify Holding or their respective owners.
- Do not connect inputs to mains.
- Disconnect power before connecting or separating modules.
- Refer to Service Guide for full cleaning recommendations.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>