SUNRICHER SR-SB1029-5C 4-In-1 Universal RF+Bluetooth LED Controller Instructions
- June 6, 2024
- SUNRICHER
Table of Contents
SUNRICHER SR-SB1029-5C 4-In-1 Universal RF+Bluetooth LED Controller
Important: Read All Instructions Prior to Installation Function introduction
Function introduction
Product Data
Input Voltage| Output Current| Output Power| Remarks| Size(LxWxH)| Ambient
Temperature| Max. Casing Temperature
---|---|---|---|---|---|---
12-24VDC| 4A/CH| 48-96W/CH| Constant voltage| 145×46.5x16mm| -20℃ ~ +50℃| 75℃
- 4 in 1 universal RF+Bluetooth LED controller, radio frequency: 2.4GHz
- 4 different device modes DIM, CCT, RGBW and RGB+CCT in 1 controller, and selectable by dial switch
- Enables to control ON/OFF, light intensity, color temperature, RGB color of connected LED lights
- Ultra powerful to control Single Color, CCT, RGBW, RGB+CCT LED strips
- Controlled through both smart App and remote controls, no gateway required for local control
- Easy & quick pairing to the smart App by simply pushing the Prog. button
- Mesh network, much longer control distance, transmits received signal to neighbor devices
- Up to 30m transmission distance between every two neighbor devices
- Encrypted two-way communication, quick status feedback, safe & reliable data transmission
- Compatible with universal RF+Bluetooth remotes, each LED controller can pair to max. 8 remotes
- Cloud control is available for remote access, works with Amazon Alexa and Google Home
- Waterproof grade: IP20
Safety & Warnings
- DO NOT install with power applied to device.
- DO NOT operate the dial switches for device mode selection with power applied to device.
- DO NOT expose the device to moisture.
Operation
Pair/delete the pairing with RF+Bluetooth remote
- Do wiring according to connection diagram.
- Pair LED controller with RF+Bluetooth remote: please refer to the instruction of the remote that you would like to pair with.
- Delete the pairing:
- Wire up the LED controller correctly, power on.
- Press and hold down the “Prog.” button on the controller for over 3 seconds (or reset power of the device 8 times continuously if the button is not accessible to factory reset the device) until the connected light flashes, which means well deleted.
Note: factory resetting will restore all configured parameters of the device on the APP to factory default setting.
Pair with smart APP
- Do wiring according to connection diagram.
- Please refer to the EasyThings App user manual for details of adding device.
Wiring Diagram
RGB+CCT Mode
Note: please make sure the dial switches are at position for RGB+CCT mode as shown in above diagram.
RGBW Mode
Note: please make sure the dial switches are at position for RGBW mode as shown in above diagram.
CCT Mode
Note: please make sure the dial switches are at position for CCT mode as shown in above diagram.
DIM Mode
Note: please make sure the dial switches are at position for DIM mode as shown in above diagram.
**Product Dimension
**
Documents / Resources
|
SUNRICHER SR-SB1029-5C 4-In-1 Universal RF+Bluetooth LED
Controller
[pdf] Instructions
SR-SB1029-5C, 4-In-1 Universal RF Bluetooth LED Controller
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>