Smart Caregiver 433-EC Caregiver Alert Monitor User Guide
- June 5, 2024
- Smart Caregiver
Table of Contents
Program Your Replacement Pad/Mat to 433-EC
Quick Start Instructions
-
ENTER PROGRAMMING MODE: Use a paperclip or a pointed tool to press and hold the “Program” button within the hole on the back of the monitor, located under “Program”. When the outer two LED Lights on the front of the monitor are solid, release pressure on the button. The lights will remain on to indicate that the monitor is in programming mode.
-
PROGRAM DESIRED COMPONENTS:
*Have components ready before starting
Cordless Sensor Pads/Mats: The transmitter must already be connected to a sensor pad and turned on. Place pressure on the sensor pad/mat and then release.
Maximum Range: Up to 300 feet.*
If programming multiple components repeat step 1 until all components have been programmed & continue to step 3 to exit programming.** -
EXIT PROGRAMMING MODE: Once the programming is complete, press and release the program button on the back of the monitor. The outer two LED lights will blink to confirm programming and turn off.
Follow us on:
https://www.facebook.com
/SmartCaregiver/|
https://twitter.com/
CaregiverSmart| https://www.youtube.com/
user/SmartCaregiver
Transmitter Instructions
Replacement Pads/Mats
- Turn on the transmitter by using a paperclip or pointed tool to press the button on the back of the transmitter.
- Once turned on, you should see the red status light blink three times and then turn off.
*Once Transmitter is turned on, it is intended to stay on for the life of the pad. DO NOT use as an ON/OFF.
REPLACING OR ADDING TO
433-CMU-40/60?
Scan for 433-CMU programming instructions
http://static.smartcaregiver.com/uploads/2020/02/433-CMU-40_60-Instructions- rev-2-13-19.pdf#page11
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Call Customer Service at800-650-3637 for assistance
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>