Chargers YM-UD22 5-in-1 Wireless Charging Station User Manual
- June 5, 2024
- Chargers
Table of Contents
Chargers YM-UD22 5-in-1 Wireless Charging Station
Product Introduction
This is a multifunctional 5 in 1 magnetic wireless charging stat旧n that can fast magnet charge your iPhone 12/13 series and simultaneously b。。sis up the Apple watch 1/2/3/4/5/6/SE, Airpods Pro/2, and supported all Qi-enabled devices
- In addition, we also designed with nightlight and USB output, which frees you from daily plug and pull hassles, and lets the wireless devices guide you to an easier life.
- The product is designed with a magnetic double coil, you could place the phone vertically or horizontally without affecting charging, and watch your favorite TV show, movies while charging
Product Details
- Requires Type C & QC 3.0 fast charging adapter when charging 3 devices with nigh lamp simultaneously or want to have a fast charging effect. We recommend that the input power must supply up to 18, otherwise it my cause multiple devices to charge insufficient or unstable.
- The base of the wireless charging station provides up to 15W fast charging. USB output provides up to 10W (max ), all qi-enabled magnetic phone charging supports 5W/7.5W/10W/15W. However, 7.5W is standard for iPhone 12 series and 3W stander for the Apple watch.
- The night lamp supports 3-level of brightness adjustable by touch control, short single touch turn on the light, and then from neutral light, warm light and warmer light and off 4 states cycled. The fourth press to turn off night lamp.
- Only compatible with magnetic enabled cases for magnetic attachment to charge wirelessly.
Product Specification
Safety Tips
Please read the instructions carefully before using the product, so that it can be used correctly and stored properly.
- Do not disassemble the product or change the actual use of the product without authorization.
- Keep away from water or other liquids which may lead to short circuits when using the products.
- Please use the product in the temperature range of -10C 45C. Do not use the product near the fire source or under sunlight.
- For safety. please place the product away from children.
- Please do not place magnetic cards, magnetic stripe media, and precision machinery too close to the device. Not for the Otterbox Commuter case.
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co located or operating in conjunction with any other antenna or transmitter. During the operation of the device, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.