HINKLEY CK1562GY Concrete Kit Taper Accessory Instruction Manual
- June 17, 2024
- HINKLEY
Table of Contents
HINKLEY CK1562GY Concrete Kit Taper Accessory
Product Information
Specifications
- Item No: KIT 1562-1563
- Manufacturer: HINKLEY
- Model: [Insert Model Number]
- Dimensions: [Insert Dimensions]
- Material: [Insert Material]
- Color: [Insert Color]
- Weight: [Insert Weight]
- Power Source: [Insert Power Source]
- Warranty: [Insert Warranty Information]
Product Usage Instructions
- On a plywood form, determine the fixture location using the paper template provided outside the pour cavity.
- Knock out or drill an alternate hole in the box to mount wire conduit (1) and attach the conduit.
- Drill through the corner 4 holes of the template with drywall screws (2) of sufficient length (not supplied) to capture the fixture box.
- Pour concrete and allow it to cure.
- Remove the corner screws (2) from the box and remove the plywood form.
- Pull the wire through the conduit up to the fixture box.
- Connect the fixture (3) following the fixture installation instructions.
Note: Measure the mounting template to make sure the dimensions on the template are correct.
FAQ
- Q: Can I mount the fixture on a different material other than plywood?
- A: While the instructions mention plywood, you can mount the fixture on other suitable materials as long as they provide sufficient support and meet the required specifications.
- Q: What should I do if the dimensions on the mounting template are incorrect?
- A: If you find any discrepancies in the dimensions on the mounting template, please contact our customer support team at the provided contact information for further assistance.
- Q: Is the wire conduit included with the product?
- A: The wire conduit is not included with the product. You will need to purchase it separately.
Assembly Instructions
Item No: KIT 1562-1563
start here
- On plywood form, determine fixture location using a paper template outside the pour cavity
- Knock-out or drill alternate hole in box to mount wire conduit (1), attach conduit
- Drill through corner 4 holes of the template with drywall screw (2) of sufficient length (not supplied) to capture the fixture box
- Pour the concrete and allow the cure
- Remove corner screws (2) from a box and remove plywood form
- Pull wire through conduit up to fixture box
- Connect fixture (3) as per fixture install instructions
Note: measure the mounting template to make sure dimensions on the template are correct.
Drawing 1 -Mounting Example
Dimension
Drawing 2- Mounting template
Contact
- 33000 Pin Oak Parkway Avon Lake, OH 44012
- 800.446.5539 / 440.653.5500
- hinkley.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>