Chargers GY-Z5 3-in-1 Fast Wireless Charger User Manual
- June 5, 2024
- Chargers
Table of Contents
Chargers GY-Z5 3-in-1 Fast Wireless Charger
PRODUCT INTRODUCTION
The 3 in 1 Wireless Charger is mult function charging staion, you can charge three smart devices (Qi smart phone, iVWatch and earbuds) on our product at the same time. It is compatble with Qi enable smart phone, iWatch, AirPods. Itis unique design with elegant appearance, and perfect to use at office or at home. Itis very convenient to charge your smart devices on Our product especially for Apple user. There is protection of over-charge and FOD function, you can en joy your charging experience safely You can turn off the light by switch
PRODUCT APPEARANCE
HOW TO USE
- Plug in the Type-C cable to power on the wireless charger.
- Place the smartphone on the charging staton and make sure it is charging.
- Put the Apple watch on the iWatch charging area to start charging.
- Place your earbuds on the charging station and make sure it is charging
LED LIGHT INSTRUCTIONS
- Green light on :
- Blue light breathing
- Blue and green flashing:
- Foreign ob ject detection working
- Standby mode
- Phone charging
APPLICABLE DEVICES
Smart Phone:
Apple: Phone 1212 Pro12 Pro Max12 mini, SE,11,11 Pro,11 Pro Max, Xs, Xs Max,
XR,x8,8 Plus Samsung: Galaxy S: 2 5G,2+5G,2 Ulta 5G,FE 5G,20 5G, 20+5G, 20
Ultra 5G, 10.10+10e,9,9+,8,8t,7,7 edge,6,6 edge,6 edge+, 6 G9209,6 Active;
Galaxy Note: 10,10e,10+,9,8,7,6,5. Huawei: P30 Pro, P40 Pro, P40 Pro+;
Mate:40E, 40 RS,40 Pro+,40 Pro,40,30E Pro, 30 5G, 30 Pro 5G, 30,30 Pro, 30 RS,
20 Pro, 20 RS, RS; Xaomi: 10.10 Pro. 9.9Pro Mix 3.Mix 2s.lIncluding other
devices with wireless charging receiver built-in;(Note: All devices must meet
the Qi standard).
Smart Watch:
Apple: iWatch $2,$3,S4,S5,S6, SE.
Earbuds:
Apple: AirPods 1, AirPods 2, AirPods Pro
PRODUCT SPECIFICATION
- Input 9V/2A 9V/2.7 or 12V/2A
- Phone Output 15W/10W/7.5W/5W
- Inputsocket Type-C
- Conversion Rate(Phone): 273%
- Product Size: 136(W)X101(D)X136(H)mm
- Watch Output 2.5W
- Earbuds Output 2.0W
WARNING
- Avoid using the product at places that are wet, humid or have high temperature.
- Avoid dropping the product from high places.
- Do not disassemble the product by yoursel ves. Please contact us if necessary
- Do not clean the product unless the unit is powered off.
- It is recommended to use 18W or above adapter to charge 3 smart devices at the same time.
FCC Statement
This device complies with part 15 FCC Rules. Operation is Subject To the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not explicitly approved by the partyresponsible for compliance could void the user’s authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC radiation exposure
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
surrounding the device and 20 cm above the top surface of the device must be
respected