SKYDANCE R14 Ultrathin Touch Slide RF Remote Controller User Manual
- June 5, 2024
- SKYDANCE
Table of Contents
R14 Ultrathin Touch Slide RF Remote Controller
Ultrathin Touch Slide RF Remote Controller
Model No.: R14
Touch color slide/RGB+W/Wireless remote 30m distance/CR2032 batter y/Magnet stuck fix
Features
- Apply to RGB+W LED controller.
- Ultra sensitive color adjustment touch slide.
- Each remote can match one or more receiver.
- CR2032 battery powered.
- Operate with LED indicator light.
- Magnet on the back which can be easily stuck on back holder or any metal surfaces.
Technical Parameters
Input and Output
Output signal| RF(2.4GHz)
Working voltage| 3VDC(CR2032)
Working current| ＜5mA
Standby current| ＜10μA
Standby time| 1 year
Remote distance|
30m(Barrier-free space)
Warranty
Warranty| 5 years
Safety and EMC
EMC standard|
(EMC) ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-17 V3.2.4
Radio Equipment|
(RED) ETSI EN 300 328 V2.2.2
Certification|
CE,EMC,LVD,RED
Safety standard|
(LVD) EN 62368-1:2020+A11:2020
Environment
Operation temperature|
Ta: -30 OC ~ +55 OC
IP rating| IP20
Mechanical Structures and Installations
To fix the remote, three options are offered for selection:
Option 1: stuck the remote on any metal surfaces directly.
Option 2: fix the remote’ back holder on the wall with two screws.
Option 3: adhere the remote’ back holder to the wall with paster.
Match Remote Control (two match ways)
Use the controller’s Match key
Match:
Short press match key, immediately press on/off key on the remote. The LED
indicator fast flash a few times means match is successful.
Use Power Restart
Match:
Switch off the power, then switch on power, repeat again. Immediately short
press on/off key 3 times on the remote. The light blinks 3 times means match
is successful.
Delete:
Switch off the power, then switch on power, repeat again. Immediately short
press on/off key 5 times on the remote. The light blinks 5 times means all
matched remotes were deleted.
Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast
flash a few times
means all matched remotes were deleted. End user can choose the suitable
match/delete ways. Two options are offered for selection:
Key function
Safety information
-
Read all instructions carefully before you begin this installation.
-
When installing battery, pay attention to the battery positive and negative polarity.
A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery. -
If no response from the receiver, please re-match the remote.
-
Gently handle remote, beware of falling.
-
For indoor and dry location use only.
User Manual Ver 1.0.4
R14 Ultrathin Touch Slide RF Remote Controller
Page 2
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>