sauermann TH 210-R Humidity and Temperature Sensor User Guide
- June 5, 2024
- sauermann
Table of Contents
sauermann TH 210-R Humidity and Temperature Sensor
Humidity and temperature transmitter
- Stainless steel or polycarbonate probes
- 2 relay outputs
- Two 4-wire analogue output 0-5/10 V or 0/4-20 mA
- ABS V0 IP65 housing with or without display
General features
Features of the housing
Symbols used
For your safety and in order to avoid any damage to the device, please follow the procedure described in this document and read carefully the notes preceded by the following symbol: The following symbol will also be used in this document, please read carefully the information notes indicated after this symbol:
Connections
- DIP switch (d)
- LCC-S software connection
- Relays
- Analog outputs (a)
- F3.20* fuse
- Power supply terminal block (c)
- Cable glands
Electrical connections as per NFC15-100 standard
This connection must be made by a formed and qualified technician. To make the connection, the transmitter must not be energized. Before making the connection, you must first check the power supply indicated on the transmitter board (see (b) in “Connections” part). The presence of a switch and a circuit breaker upstream the device is compulsory
- For transmitters with 24 Vdc power supply:
- For transmitters with 24 Vac power supply:
- For transmitters with 100-240 Vac power supply:
The selection of the output signal in voltage (0-10 V or 0-5 V) or in current
(4-20 mA or 0-20 mA) is made via the DIP switch (d) of the electronic board of
the transmitter: put the on-of switches as shown in the table
below:
- Connection of the output in current 4-20 mA:
- Connection of output in voltage 0-10 V:
On 100-240 Vac models, if a fuse protection is used for the power line, it is imperative to use delayed-action fuses in order to absorb the surge of current when first turned on the transmitter.
Transmitters configuration
It is possible on the class 210 to configure all the parameters of the transmitter: units, measuring ranges, outputs, channels, calculation functions, etc. via different methods:
- Keypad for models with display: a code-locking system allows to secure the installation (See class 210 transmitters user manual).
- Software (optional) on all models. Simple user-friendly configuration. See LCC-S user manual.
Configurable analogue output:
Range with center zero (-40/0/+40 °C), with offset zero (-30/0/+70 °C) or
standard range (0/+100 °C). It is possible to configure your own intermediary
ranges
Caution: the minimum difference between the high range and the low range
is 20. Configure the range according to your needs: outputs are automatically
adjusted to the new measuring range
Mounting
To mount the transmitter, mount the ABS plate on the wall (drilling: 50 Ø 6 mm, screws and pins are supplied). Insert the transmitter on the fixing plate (see A on the drawing beside). Rotate the housing in a clockwise direction until you hear a “click” which confirms that the transmitter is correctly installed.
Accessories
Please refer to the datasheet to get more information about available accessories.
Maintenance
Please avoid any aggressive solvents. Please protect the transmitter and its probes from any cleaning product containing formalin, that may be used for cleaning rooms or ducts.
Precautions for use:
please always use the device in accordance with its intended use and within the parameters described in the technical features in orderm not to compromise the protection ensured by the device.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>