realme RMH2011 Smart Scale User Manual

realme RMH2011 Smart Scale

Warning
The product is forbidden to be dismantled, extruded, stabbed or short- circuited randomly or put in water or fire or exposed in an environment with a temperature higher than 60C (140 FP.
AA person installed with a cardiac pacemaker or other medical appliances is forbidden to use this product. A pregnant woman should use this product with caution and should follow the doctor’s advice.
CAUTION:
Risk of explosion if the battery is replaced by an incorrect type. Replace only with the same type alkaline battery.
Disposal of a battery into fire or a hot oven, or mechanically crushing or Cutting of a battery, that can result in an explosIon, Leaving a battery in an extremely high temperature surrounding environment that can result in dn explosion or the leakage of flammable liquid or gas; A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

Important Instruction
This product is not a medical appliance.
The measured data from the realme body fat Scale are for reference only and should not serve as a basis for medical opinions.

Declaration
Body data about the following groups may be inaccurate:

• Minor
• Professional athlete
• Pregnant woman
• A patient with a cardiac pacemaker

Basic Parameters

• If the scale is used for the first time or moved, the body weight obtained may have a deviation (about 2kg). Please remeasure yourself on the scale (The scale will automatically adjust itself.) and get an accurate measurement result.
• Before measuring yourself on the scale, please place the product on a solid and flat floor to guarantee measurement accuracy.
• Don’t place the scale on a wet and slippery floor and don’t measure yourself when your feet or the weighing panel are wet lest you slip.
• The surface of this product is made of glass. To guarantee safety, please avoid weight impact or falling lest the glass be broken to hurt you. Before measuring yourself, please confirm that the scale surface is not damaged.
• The using environment should be dry. The body fat scale cannot be immersed in Water
• The surface of the body fat scale should be scrubbed with a wet cloth and neutral detergent and cannot contact organic solvent or other chemicals.
• When the batteries are exhausted, please take them out in time lest the leaked liquid from the batteries corrodes the scale body.

Product Information

Basic Parameters

• Product Model: RMH2011
• Product Size: 300’300 23.25mm (including the electrode and scale base)
• Net Weight of the Product: 1.74kg
• Unit: kg/lb
• Display Method: LED panel
• Power Source: 4’1.5V AAA batteries
• Weighing Scope: 50g~ 150kg
• Working environment: 5 C~ 40C
• Frequency Range: 2402 2480MHz
• Storage environment: -20 C~ 60C
• Transmit Power (EIRP): 0.67dBm

Packing List

• realme Scart Scale      1
• 1.5V AAA battery    4
• Operating manual & warranty card  1

Operating Manual

1. Install batteries
   Take the scale from the plastic bag, open the battery case at the bottom of the SCale, pull out the insulation sheet from the battery jar and cover the battery Cover.

2. Application Installation and Using Help Scan the QR code below to install the [realme Link] APP or scan the QR code about [Using Help to obtain relevant instructions.

3. 3 Bind the body fat scale
   Display Screen
   After the measurement is completed successfully, the measured data will be uploaded to the realme Link APP (The data about heart rate can only be displayed on the scale for the present.). You can check the data and analysis in the APP.
   

4. Click the button of “Step on” in the APP and measure yourself barefooted
   Begin to use

   • Correct standing posture
   • The feet should be distributed naturally at both sides with the scale center as an original point
     Note: In order to guarantee data accuracy, you are suggested to adopt a correct standing posture barefooted for the measurement.

5. Heart rate measurement: Heart rate measurement will begin after the data about weight is locked and displayed for 3 seconds.

Troubleshooting

• The mobile phone configuration does not support the product. Please refer to the following requirements about mobile phone system
  Supporting system Android 5.0 and above, Bluetooth 4.0 and abovve

• Insufficient electric quantity of the scale
  After the battery voltage is lower than 4.2V, the body fat scale will initiate lower electricity reminder and the screen will show “Lo” but the use of the product will not be affected.When the battery voltage is lower than 4.0V, the body fat scale will entera state of empty power and the screen will show “Lo”. The equipment will be automatically powered off in 3s. The screen will show:Lo
  The network signal for the mobile phone is weak

• (WiFi or 4G network is recommended)

• The mobile phone Bluetooth is not initiated

Warning

1. EU Declaration of Conformity (DoC)
   Hereby, realme, declares that this device is in compliance with the essential requirements and other relevat provisions of Radio Equipment Directive 2014/53/EU. The declaration of conformity may be consulted at www.realme.com/global/support/eu- declaration.

2. Recycling Initiative
   At realme we understand that our responsibility doesn’t end at selling you our products. realme have been working in the area of safe disposal of electronic Waste. Since mobiles, wearables and other electronic items are made of hazardous constituents. Under the Guidelines of Ministry of Environment, Forest and Climate Change, Government of India, E-waste (Management) Rule, 2016 and Amendment E-waste Rule 2018.

• realme will seek shared responsibility and cooperation from customers in reducing the environmental impact of their products.
• realme will comply with all the applicable laws related to e-waste management.

As a part of e-waste recycling initiative, redlme have partnered with an authorized e-waste company named as 3R Recycler for the collection, dismantling and disposing E-waste collected from all over India. 3R vision is to look at e-waste not just as waste, but as an important resource that can be made useful instead of shunning it as a social and environmental burden with their fully automated facility for e- Waste recycling. For further information aboute-waste recycling and our e-waste recycling partner & their process you may log on to www.3rrecycler.com or write an email to admin@3rrecycler.com Call us on toll free hotline 1800 102 8632.

realme
Contact Information:
Company: Realme Chongqing Mobile Telecommunications Corp., Ltd.
Address: No. 178 Yulong Avenue, Yufengshan, Yubei District, Chongqing, China
Service Website: www.realme.com

Warranty Policy and Customer Service Information

Thank you for purchasing the product of realme. If any quality problems arise within 12 months as from the date of purchase, you can enjoy the company’s warranty service.

Matters Needing Attention:

1. When you buy the product, the sales unit will issue a valid proof of purchase.
2. The warranty card and proof of purchase should be kept properly and will not be reissued if you lose them.
3. As to failures caused by non-human factors, the user can enjoy free maintenance at the customer service center of realme by showing his/her
   Warranty card and proof of purchase within the warranty period.

Non-Warranty Circumstances:
Any of the following cases is not within the warranty scope during the using process.

1. The warranty period expired.
2. Damages caused by using the product not in accordance with the operating manual or operating guide.
3. Damages caused by human factors.
4. Failures caused by illegal dismantlement, maintenance or modification of the product.
5. Damages caused by force majeure factors. (flood, earthquake, lightning, etc).
6. There is no warranty card or invoice or the information of the warranty card is inconsistent with the information of the invoice.
7. Natural abrasion of the product.
8. Failures and damages caused by factors other than quality problems of the product.

Warranty Card (Stub Copy)
Dear user, thank you for using the product of this company. Please read and keep properly the warranty card after purchasing the product so that we can provide better services to you.

• User’s Name
• Contact Tel
• User’s Address
• Email
• Product Information
• Product Model
• Sales Information
• Purchase Date
• Invoice Number
• Sales Unit
• Sales Address
• Tel
• Product Serial Number

Warranty Card (Customer Copy)
Dear user, thank you for using the product of this company. Please read and keep properly the warranty card after purchasing the product so that we can provide better services to you.

• User’s Name
• Contact Tel
• User’s Address
• Email
• Product Information
• Product Model
• Sales Information
• Purchase Date
• Invoice Number
• Sales Unit
• Sales Address
• Tel
• Product Serial Number

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>