sauermann Si-C320 Pressure Relay and Wireless Modules User Guide
- May 15, 2024
- sauermann
Table of Contents
sauermann Si-C320 Pressure Relay and Wireless Modules
Specifications:
- Pressure Modules: Si-PRO-DP-50, Si-PRO-DP-250, Si-PRO-DP-1000, Si-PRO-DP-10000, Si-PRO-ATMO
- Wireless Communication Module: Si-ACC-WLM
- Relay Module: Si-M4R
Product Usage Instructions
Pressure Module Installation:
- Unscrew the plug screw of the drilling for the pressure connections.
- Put the two pressure connections and tighten them.
- Keep the pieces in which the pressure connections must be screwed.
- Place the pressure board matching the holes for spacers and the red connector.
- Ensure the pressure board is correctly inserted.
- Close the transmitter and refer to the full user manual to set the differential pressure range.
Wireless Communication Module Installation:
- Hold the wireless communication module between your fingers as shown on the picture and slide it between the two holders.
- Ensure the wireless communication module is correctly inserted.
- Close the transmitter and refer to the full user manual to set up wireless communication.
Relay Module Installation:
- Place the relay module by matching the holes for spacers and the red connector.
- Ensure the relay module is properly installed and functional.
FAQ:
-
Q: Can these modules be connected while the transmitter is energized?
A: No, it is important to ensure that the transmitter is not energized while connecting any of the modules (pressure, wireless, or relay). -
Q: What should I do if I encounter difficulties during the installation process?
A: If you face any issues during installation, refer to the detailed operating instructions available at sauermanngroup.com or seek assistance from a qualified technician.
Quick Start Guide
- These operating instructions describe how to connect a wireless module and a pressure module to a Si-C320 transmitter.
- Please refer to the operating instructions available at sauermanngroup.com for safe use of the Si-C320 and detailed information.
- Do not give these devices to a child.
Symbols used
- For your safety and to avoid any damage of the device, please read carefully the notes preceded by the following symbol:
Pressure module
- While connecting the differential pressure module, the transmitter must not be energized.
- These instructions apply to the following pressure module references: Si-PRO-DP-50/Si-PRO-DP-250/Si-PRO-DP-1000, Si-PRO-DP-10000 and Si-PRO-ATMO.
- Once the module is connected, close the transmitter and refer to the full user manual to set the differential pressure range.
Wireless communication module
- These instructions apply to the following wireless communication module: Si-ACC-WLM
- While connecting the wireless module, the transmitter must not be energized.
- Once the module is connected, close the transmitter and refer to the full user manual to set the wireless communication.
Relay module
- These instructions apply to the following 4-relay module: Si-M4R
- While connecting the 4-relay module, the transmitter must not be energized
Make the most of your device’s capabilities by downloading the app.
Access all documentation about the device
Customer service portal
https://sauermann-en.custhelp.com
QSG – Si-PRO-DP_Si-ACC-WLM_Si-M4R_Si-PRO-ATMO – 06/03/2024 – Non-contractual document – We reserve the right to modify the characteristics of our products without prior notice
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>