LifeStraw Peak Series Gravity Water Filter System 3L User Manual

LifeStraw Peak Series Gravity Water Filter System 3L

OVERVIEW

HOW TO USE

1. Assemble. Attach the membrane microfilter to the gravity bag by first unscrewing the plug cap, then screw the filter onto the outside of the neck cap. Tighten until secure.
2. Attach Hose. Connect the included hose to the exposed outlet of the filter. Make sure the pinch clip is tighten to prevent water from flowing until you’re ready.
3. Fill. When ready to use, unscrew the neck cap to expose the gravity bag opening. Fill with water, and retighten the cap to close.
4. Hang. To use as gravity system, hang the reservoir to an anchor point using the strap to secure.
5. Ready to Use. Release the pinch clip on the hose to allow filtered water to flow through, letting gravity do the work! Note: these instructions are based on using the product as a gravity system. The 3L bag can also be used for water storage with the included cap or as a squeeze bag system.
6. Close filter. When finished filtering, we recommend removing the hose from the filter, then unscrewing the filter from the outside of the neck cap and screwing it inside of the bottle. This will keep it protected. Use the plug cap on the end of the neck cap to keep everything secure and prevent leakage.
7. Maintenance and Storage. Regularly backwash your filter after use to keep the filter clean and to prevent clogging. To do this, disconnect the membrane microfilter by twisting counterclockwise. Then, screw the included backwash syringe onto the membrane microfilter. Plunge the open end of the filter into drinking water, and draw water up through the filter by pulling the syringe upward and away from the filter until it reaches the edge of the housing. Then push water back through the filter by pressing the syringe downward toward the filter until the water has been fully pushed through the other side. If storing your LifeStraw Peak Series 3L Gravity Water Filter System for greater than 1 month without use, we recommend following our long term storage instructions to preserve the longevity of the filter and to prevent

LONG-TERM STORAGE INSTRUCTIONS

Avoid drying out the filter by storing with a saline solution made by mixing a teaspoon of salt with water. This will keep the filter at its highest performance and maintain the hydrophilic properties of the membrane, while also preventing any mold or algae from growing during long-term storage. When the membrane becomes completely dried out, it can be difficult to get water to flow through again. Follow these steps if you have already used the LifeStraw Peak Series filter and you plan to store for greater than 1 month without use. If storing for longer than 3 months, we recommend cleaning with a diluted bleach solution prior to storage for increased disinfection. These instructions can be found at www.lifestraw.com.

Immerse in Salt Solution.
Using a reusable container, dissolve 1 teaspoon of salt with 2 cups of water. Place the filter into the saline solution and use the backwash syringe to pull water fully into the filter. Place the filter into the reusable container, still filled with salt water, and seal tightly. Once the filter is removed from the system, the bag can be cleaned with household soap and water before setting out to dry.

Store.
Store container with the salt water in a cool dry place. If storing the gravity bag, make sure the caps are open before storage.

Resume Use.
To use your Peak Series filter again, discard the salt solution and fill a cup or container with regular source water. Use the backwash syringe to remove residual salt water from the filter by pulling in the new water and pushing back through the filter. If you have additional questions about storage and maintenance for your LifeStraw Peak Series products, please email us at remy@lifestraw.com

TIPS

Test your gear before you go! Follow the how to use instructions to make sure your LifeStraw Peak Series 3L Gravity Water Filter System is operating as you expect it to. Slow flow rate? Use the backwash instructions to remove potential air bubbles in the membrane. Questions? Contact remy@lifestraw.com – we’re here to help!

DISCLAIMER
Vestergaard Frandsen Inc. and its affiliated entities and related companies shall be neither liable for any damages arising out of or as a result of the use of LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System for any purpose other than for which it is clearly intended, nor for any malfunction resulting from the failure of the user of LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System to strictly abide by the usage and safety information contained in this manual. Stated microbiological and longevity performance of LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System is conducted under standard laboratory test conditions; more information regarding test results and conditions can be found at www.lifestraw.com. The effectiveness of LifeStraw product may be limited by environmental or hygienic conditions that could contribute to the recontamination of water after it has passed though the product’s internal filter. These conditions include but are not limited to:

1. Handling the mouthpiece with dirty / contaminated hands.
2. Failure to maintain a clean mouthpiece and exterior.
3. Failure to discontinue use of the product per manufacturer’s recommendations.
4. Using the filter if the plastic is cracked.
5. Use in or exposure to extreme heat (higher temperature than 140°F/60°C) or freezing temperatures (below 32° F/0°C).

Read these usage and safety instructions carefully before using LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System. LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System is a personal water filtration tool and should only be used for filtering water. The quality of the filtered water is not guaranteed if the product is submitted to conditions other than those encountered during its normal use. Your use of LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System implies that you accept and agree to these terms, conditions, and disclaimer.

CAUTION
Drinking untreated water may expose you to harmful microorganisms and increase your risk of gastrointestinal illness. Improper usage of LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System increases your risk of exposure to harmful microorganisms and increases your risk of gastrointestinal illness. Reduce your risk of becoming sick by following these safety instructions and by educating yourself on backcountry water safety. Never use LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System to filter seawater or chemically contaminated water, including water from mining tailing ponds or from near large agricultural operations. Rinse the bottle and top cap with safe water before first use. DO NOT DROP or place pressure on this product in any manner. The intentional or unintentional impact of this product on a solid surface may damage the filtration mechanism within the LifeStraw Peak Series Collapsible Squeeze Bottle Water Filter System and render it inefficient and unusable. This product must not be used by children without the supervision of an adult.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>