FYSIC FXA-100 SOS Emergency Button with GPS Tracker for Seniors Installation Guide

June 5, 2024
Fysic

FYSIC FXA-100 SOS Emergency Button with GPS Tracker for Seniors

FYSIC FXA-100 SOS Emergency Button with GPS Tracker for Seniors-
prod

INSTALLATION GUIDE

  1. SIM card:
    Choose the format: Nano-SIM Make sure that the SIM PIN code is disabled and the SIM is already activated on another mobile phone

  2. On the right side of the alarm button, pull the rubber cover “SIM-CAP” to the right and turn it upwards

  3. Slide the Nano SIM card into the slot and press it until it clicks into place

  4. Turn and snap the rubber closure back into place

  5. Charging:
    Charge the alarm key before first use Insert the USB plug into the back of the charger

  6. Put the alarm key on charge It takes about 8 hours for an empty battery to be fully charged When the battery is almost empty, an SMS message can be sent to SOS No. 1

  7. You can also charge without the charging station: To do this, turn the rubber USB cover upwards and insert the plug here.

  8. Switching on:
    Turn on the alarm key by pressing and holding the key with the red cone for 4-5s. Charge the product before turning it on.

  9. Setting up:FYSIC FXA-100 SOS Emergency Button with GPS Tracker for Seniors-fig9 The system is set up by sending SMS messages to the emergency key number using another phone.

  10. GPS Initialisation:

The alarm key must initialize the GPS system properly at first. It is important to do this properly at first so that you can make optimal use of the GPS reception in future.

  1. Program an SOS number as described above.
  2. Activate the SOS on the alarm key, but do this outside where you can be assured of good GPS reception.
  3. Accept the emergency call on your smartphone and wait until you receive the location (during the call) by SMS. This is most likely another Network Location determination.
  4. The call may be disconnected
  5. Wait 5 minutes.

Repeat steps 2, 3 and 4 until you receive an SMS via GPS Location. If you still receive the SMS with a Network Location, repeat these steps at a different outside location. If it still does not work, please contact our Service number (see Manual).

Specifications

Network: GSM900 / DSC1800 / WCDMA / LTE / WIFI SAR: <0,4W/kg/<0,6W/kg/<0,3W/kg/<0,4W/kg/<0,1W/kg

  • Power: GSM: 880-960MHz  < 2W
  • DCS: 1710-1880MHz  < 1W
  • WCDMA: 1850MHz-1990MHz  < 0.2W
  • LTE: 1920-2170MHz  < 0.2W
  • WIFI: 2412-2484MHz < 0.1W

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals