Fysic FK470 FM Alarm Clock User Manual
- June 9, 2024
- Fysic
Table of Contents
FK470 FM Alarm Clock
User Manual
FK470 FM Alarm Clock
CAUTION:
Usage of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
This unit should not be adjusted or repaired by anyone except qualified
service personnel.
PRECAUTIONS BEFORE USE
KEEP THESE INSTRUCTIONS IN MIND:
- Do not use this device near water.
- Clean only with a slightly damp cloth.
- Do not cover or block any ventilation openings. When placing the device on a shelf, leave 5 cm (2”) free space around the whole device.
- Install in accordance with the supplied user manual.
- Don’t step on or pinch the power adaptor.
- Do not place heavy items on the power adaptor, which may damage it.
- Keep the entire device out of children’s reach!
- Unplug this device during lightning storms or when unused for a long period.
- Keep the device away fromexternal heat sources.
- Avoid using the device near strong magnetic fields.
- Warning! Never insert an object into the product through the vents or openings.
- Do not use in wet or moist areas such as bathrooms.
- This device must operate on a power source as specified on the specification label.
- Always hold the plug when pulling it out of the main supply socket.
- Although this device is manufactured with the utmost care and checked several times before leaving the factory, it is still possible that problems may occur. If you notice smoke, an excessive build-up of heat or any other unexpected phenomena, you should disconnect the plug from the main power socket immediately.
- This device is not intended for use by people (including children) with physical, sensory or mental disabilities, or a lack of experience and knowledge, unless they’re under supervision or have received instructions about the correct use of the device by the person who is responsible for their safety.
- This product is intended for non professional use only and not for commercial or industrial use.
- Make sure the unit is adjusted to a stable position.
- Never place this apparatus on other electrical equipment.
*** Do not ingest the battery, Chemical Burn Hazard.
This product contains a coin/button cell battery. If corn/button cell battery
is swallowed, it can severe internal burns in just 2 hours and can lead to
death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and
keep it away from children.
If you think batteries might have swallowed or placed inside any part of the
body, seek immediate medical attention.
- The battery CR-2032 is not included.
Caution
Danger of explosion if battery is incorrect replaced.
Replace only with the same or equivalent type.
1. Sleep timer
2. Tuning – / Hour +
3. Tuning + / Minute +
4. Time Set
5. Snooze / Light dimmer
6. Preset radio memory
7. Volume – / Alarm 1 Set
8. Volume + / Alarm 2 Set
9. Radio on-off / Alarm Off| 10. Snooze Indicator
11. LED Display
12. 1st Alarm Indicator Buzzer
13. 2nd Alarm Indicator Buzzer
14. 1st Alarm Indicator Radio
15. 2nd Alarm Indicator Radio
16. Battery compartment
17. Speaker
18. Main Plug(AC Cord)
---|---
RADIO TUNING
- Press the ON/OFF button to turn the clock radio on or off.
- Adjust the “TUNING+” or “TUNING-” to select the desired stati- on: short press the TU+ button for manual tune, long press the TU+ button for automatic search of the next station.
- Press the “VOL +” or “VOL -” button to adjust the volume.
RADIO PRESETS AND MEMORY
- You select a station by following point 1 and 2 from the radio tuning section above
- Long press PRE/M+, the display will blink on a preset number like P01 or P02…
- by pressing VOL-/AL1 button the preset number will decrease; by pressing VOL+/AL2 button, the preset number will increase and is still blinking.
- If you are ready choosing the preset number, short press the PRE/M+ button to save the station in this selected preset.
- To recall a preset, just short press the PRE/M+ button and the display will show the the radio station saved in the next preset number.
SETTING THE ALARM
-
You must switch off the radio before you set the alarm time.
-
Short Press “ALARM 1” or “ALARM 2” button:
Now you can select to wake up by radio or buzzer. The LED with bell logo stands for wake up to buzzer.
The LED with music note logo stands for wake up to radio.
Press “ALARM 1” button to select different wake up modes. -
To set or modify the alarm time you should long press VOL-/AL1 button and the display will blink
-
Now you can press the hour and minute buttons to adjust the selected alarm time.
-
To confirm the alarm time, short press the VOL-/AL1 button.
-
You can repeat those operations for setting alarm 2
CANCELING THE DAILY ALARM
Press the “ALARM OFF” button to stop the alarm. The alarm will operate 24
hours later as per alarm Time set.
CANCELING THE ALARM
Press the “ALARM 1” or “ALARM 2” buttons until all wake up mode icons on
display have disappeared. The alarm setting is cancelled now.
SETTING THE CLOCK
- You must switch off the radio before you set the clock time.
- Press and hold the “TIME SET” button until the display begins to blink, then release the button.
- Press the Hour and Minute button to adjust the hour and minute.
- Press the “TIME SET” button to save time
SETTING THE SLEEP TIME
Press the Sleep button repeatedly to set the sleep time (90, 80, 70, 60, 50,
40, 30, 20, 10 min or OFF).
SNOOZE
To use the snooze, press the SNOOZE bar when the alarm is soun- ding. The
alarm will stop temporarily, but will resume sounding after 9 minutes.
DIMMER
You can select the brightness of the display by pressing the Snooze/Dimmer
button.
There are 3 positions: dark, mid and high brightness.
SPECIFICATIONS
Frequency Range: FM 87.5 –108 MHz
Power Source: AC 230V ~ 50 Hz, 3W
DC 1 x CR2032 batteries (For back-up, not included)
Power Output: 300 mW
DISCARDING OLD EQUIPMENT
**** Old electric and electronic devices often contain valuable materials.
However, they also contain
harmful substances that were necessary for their functionality and safety. If
these are placed with the non-recyclable waste or disposed of incorrectly,
they can be harmful to human health and the environment.
Never place your device with the non-recyclable waste.
The full text of the EU declaration of conformity is available at the
following internet address: http://DOC.hesdo.com/FK470-DOC.pdf
WARRANTY
We provide a warranty of 24 months for this product. The warranty starts on
the date of purchase and is intended for faults due to production or the used
materials.
Your statutory warranty rights in accordance with § 439 ff. BGB-E will remain
unaffected by this.
The warranty does not apply to damages as a result of improper handling or
use, nor to malfunctions that only have a minor effect on the functionality or
value of the product. Normal wear and tear, transport damage, to the extent
that we are not responsible for this, as well as damages caused by repairs not
performed by us, are also excluded from the warrant.
This device is designed for household use and has the right performance
levels.
Any use in commercial situations is only covered by the warranty if the device
is not put under a heavier strain that in a household situation. The device is
not intended for additional commercial use.
In the case of well-founded complaints, we will repair the defective device at
our discretion or replace it with a device that shows no problems.
WARRANTY
Updates to Firmware and/or hardware components are made regularly. Therefore
some of the instruction, specifications and pictures in this documentation may
differ slightly from your particular situation. All items described in this
guide for illustration purposes only and may not apply to particular
situation. No legal right or entitlements may be obtained from the description
made in this manual.
| WWW.FYSIC.NL
SERVICE@FYSIC.NL
---|---
Commaxx B.V., Wiebachstraat 37
6466 NG Kerkrade, The Netherlands