TESY MC 20111 Radiant Panel Heater Instruction Manual

RADIANT PANEL HEATER 2-6
Operation and Storage Manual of Panel Heater Equipped with MICA Heating Element

MC 20111
230V 50Hz 2000W

This product is only suitable for well-insulated spaces or occasional use. |

IMPORTANT SAFETY MEASURES AND PRECAUTIONS:

• Please read this manual before operating the appliance and keep it at a safe place for future reference. In case the appliance is obtained by a new owner, it should be transferred together with its manual.

• CAUTION: Children under 3 years of age should be kept away from the appliance unless they are under constant supervision. Children from 3 to 8 years of age are allowed to operate the on/off button ONLY, provided that the appliance is installed and ready for operation and such children have been supervised and instructed in safe operation of the appliance and they understand all related risks.
  Children from 3 to 8 years of age MUST NOT: connect the plug to power sockets, make adjustments, clean it or carry out user maintenance operations. This appliance can be used by children older than 8 years of age and by people with reduced physical, sensor, and mental capabilities, as well as by people with insufficient experience and knowledge provided they are supervised or instructed in the safe operation of the appliance and understand the related risks. Children should not be allowed to play with the appliance. Cleaning and user maintenance operations must not be carried out by children without supervision.

• CAUTION: Some of the appliance parts may get very hot during operation and thus cause burns to users. In case there are children and vulnerable people in the room, special attention should be paid.

• WARNING: In order to avoid overheating, do not cover the appliance!

• The appliance should not be positioned right under a power socket!

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.

• Before operating the appliance – check if the voltage indicated on the appliance technical plate corresponds to the voltage of the electricity, supplied to your place.

• This appliance must be used only for the operations it has been designed and intended for, i.e. heating of domestic premises.

• This appliance is not intended for commercial application. Every kind of different application is considered improper and consequently dangerous. The manufacturer does not bear responsibility for malfunctions resulting from improper and irrational operations. Nonadherence to these safety instructions will render the guarantee terms invalid!

• DO NOT leave your place while the appliance is operating: ensure that the power switch knob is switched to the OFF position. Always disconnect the power plug from the socket.

• Keep inflammable objects, such as furniture, pillows, bedding, paper, clothes, curtains, etc. at a distance of at least 100 cm away from the panel heater.

• Do not operate the appliance in areas of use or storage of combustible substances. Do not operate the appliance in areas of combustible media (for example in close proximity to inflammable gases or aerosols) – there is a great risk of explosion and fire!

• Do not insert and do not allow foreign objects to enter the ventilation openings (inlet and outlet) because this will cause electric shock, fire or will damage to the panel heater.

• This appliance is not suitable for animal breeding and it is intended for domestic use only!

• Keep the air inlet and outlet clear of any objects: an unobstructed distance of at least 1 meter in front and 1 meter behind the panel heater should be provided.

• The most common cause of overheating is fluff and dust deposits in the appliance. Clean the ventilation openings regularly with a vacuum cleaner. Before that disconnect the power plug from the socket.

• Never touch the appliance with damp or wet hands – there is a danger to your life!

• The power socket must be easily accessible all the time in case the power plug has to be disconnected as fast as possible! Never pull the power cord or the appliance itself in order to disconnect it from the mains.

• ATTENTION! Outgoing air gets hot during operation (up to more than 100°C).

• Do not cover the appliance. If the appliance gets covered, there is a risk of overheating.

• If the appliance is damaged or does not work properly, stop it and do not repair it yourself. For any kind of repairs call for assistance after-sale service center. This is the place where you will have your broken part replaced with an original one. Nonadherence to this instruction will compromise the appliance’s safety.

• If you decide to stop using such kind of appliance, it is advisable to render it unusable by cutting its power cord after disconnecting it from the mains. It is advisable all possible dangers related to the appliance be prevented, especially in relation to children that may play with out-of-use appliances.

• Never keep the appliance unnecessarily switched on. Disconnect it from the power socket when you do not intend to use it for a long period of time.

• Warning: Do not use this appliance with a programming device, counter, or any other device which can automatically switch it on, because if the appliance is covered or improperly positioned this may cause a fire.

• Position the power cord in such a way that it does not obstruct the free movement of people and cannot be stepped on! Use only approved extension cords that are suitable for this appliance, i.e. have got a conformity sign!

• Never move the appliance by pulling its power cord and do not use the power cord for carrying objects!

• Do not bend the power cord and do not stretch it over sharp edges, do not position it over hot plates or open flames!

• Never use this appliance in close proximity to wet premises – bathroom, a shower cabin, or a swimming pool!

PACKING

• After unpacking the appliance, check if all its elements are included in the packing and that it has not been damaged during transportation! In case damage or incomplete delivery is found, contact your authorized retailer!
• Do not throw away the original packing! It could be used for storage and transportation purposes in order to avoid damages during transportation!
• Disposal of packing materials should be done in the appropriate way! Children should be prevented from playing with polyethylene bags!

INSTALLATION AND OPERATIONS INSTRUCTIONS

Indoor use only
You need to install the provided rollers by tucking them under the base. (The installation of the rollers does not need any tool, only by hands, see the below picture)

Important! Never use the heater without its rollers correctly in position!

1. Fix the caster into the feet mounting hole(Figure 1).
   Fix the 2 feet into the bottom groove of the radiator, and double-check the R&L distinguish (Figure 2).
   

2. Install the provided handle at the back of the appliance by fixing the two screws as shown (Figure 3) with 2 screws of 4*14 is fixed into the correspond hole.
   Thank you for choosing panel heater MC 20111. This is a product that provides heating in winter depending on the consumers’ needs for comfortable room temperature. If operated and taken care of properly in accordance with these instructions, the appliance will provide you with many years of useful operation.

USE
This appliance can be operated by the manual controls located on the side of the heater:

1. Power button

There are four different positions.

• Stop: 0
• Low heating: 750W
• Medium heating: 1250W
• Maximum heating: 2000W

2. Adjustable thermostat

• The appliance is equipped with a thermo-regulator sensitive to ambient temperature. You can turn the thermo-regulator knob until the desired room temperature is achieved (the size of the heated room has to conform to the power of the appliance; in case the desired room temperature can not be achieved, an additional panel heater needs to be operated). You may turn the thermostat knob clockwise to the maximum level (HI) and when the desired room temperature is achieved you have to turn the switch counter-clockwise slowly until a “ticking” sound is heard. After that, the appliance will maintain the room temperature at the adjusted level by switching on and off automatically.
• The appliance has got an in-built anti-frost function. In case you decide to use the appliance in a room, where the minimum temperature is to be maintained (winter gardens, cellars or attics), the appliance has to be adjusted to the desired heating level (level I, level II or both), the thermostat knob has to be turned counter-clockwise until it reaches the smallest indicator reading. In this position the appliance will maintain room temperature in the range of 5±2°С – i.e. it will periodically switch on and off, maintaining the adjusted level of temperature comfort in the room.
• The available power levels are presented indicatively.

Note: The device shows the temperature around the location of the sensor and is not a means of accurately measuring the ambient temperature.

MOVING OF THE APPLIANCE:

If the appliance has to be moved, switch it off by the Heater switch, and if a fan is available in your appliance switch it off by the Fan switch. Take the power plug out of the power socket, holding the appliance handles with both hands, and move it to its new position, having in mind that the appliance must get cold (cooled down) before doing this. Moving hot appliances may lead to undesired consequences for the user like burns or entering of inflammable materials entering the panel heater during its movement.

IN-BUILT OVERTURN (FALL) PROTECTION SWITCH
The panel heater has got an in-built overturn protection switch. In case the panel heater overturns, the power supply will be stopped. Let the panel heater cool down and then put it into an upright position again. The appliance will restore its normal operation.

AUTOMATIC SAFETY STOP

There is an in-built device in the panel heater (self-restoring thermal switch), which actuates automatically and switches off the panel heater in case of overheating. The thermal
the switch will restore its normal state when the appliance temperature decreases to its normal level.

Important!
It is possible during the initial operation of the appliance a specific odor is emitted. This is normal during the initial period of operation. Ensure that the panel heater is used in a
well-ventilated room and let it work until the odor disappears.
You may hear a specific sound resembling popping until the panel heater warms up. This is normal and the panel heater operates in normal mode. As soon as the panel heater warms up this sound will disappear.

CLEANING

• It is compulsory first to switch off the appliance and disconnect its power cord from the socket. Before starting cleaning the panel heater you should wait until it cools down after disconnecting it from the power socket.
• Clean the body of the appliance with a damp cloth, vacuum cleaner, or soft brush.
• Never immerse the appliance into the water – there is a danger to your life from electric shock!
• Never use petrol, thinner or coarse abrasive products for cleaning because they will damage the surface coating of the appliance.

STORAGE

• Before putting away the panel heater let it cool down after disconnecting it from the power socket.
• Use the original packing for storing the panel heater if it will not be used for a certain period of time. The product is protected from excessive dust and dirt when it is kept in its original packing.
• Never put a hot appliance into its packing!
• The product is necessary to be stored at a dry place away from direct sunlight.
• It is explicitly forbidden to store the appliance in wet or damp premises.

TECHNICAL CHARACTERISTICS OF THE APPLIANCE:

Environment protection instructions
**** Old electric appliances contain valuable materials and therefore should not be disposed of as domestic waste! We ask you for your active cooperation to protect the resources and the environment by submitting your appliance to organized buy-back stations (if there are such).

TABLE 2: INFORMATION REQUIREMENTS FOR ELECTRIC LOCAL SPACE HEATERS
Model identifier(s): 1.MC20111 2000W/230V~ 50Hz

Nominal heat
output| Phnom| 2| kW| Manual heat charge control, with integrated thermostat| [yes/no]
Minimum heat
output (indicative)| Pin| 0.75| kW| Manual heat charge control, with room and/ or outdoor temperature feedback| [yes/no]
Maximum
continuous heat
output (indicative)| Pmax,C| 2| kW| Electric heat charge control, with room and/or outdoor temperature feedback heat charge control, with integrated thermostat| [yes/no]
Auxiliary electricity
consumption| | | | Fan-assisted heat output| [yes/no]
At nominal heat
output| elmax| N/A| kW| Type of heat output/room temperature control (select one)| –
At minimum heat
output| Elgin| N/A| kW| Single-stage heat output and no room temperature control| [no]
In standby mode| el SB| 0.0004| kW| Two or more manual stages, no room
temperature control| [no]
With mechanic thermostat room temperature control| [yes]
---|---
With electronic room temperature control| [no]
With electronic room temperature control plus a day timer| [no]
With electronic room temperature control plus a week timer| [no]

Other control options (multiple selections possible)

TESY Ltd – Head office
1166 Sofia, Sofia Park,
Building 16V, Office 2.1. 2nd Floor
PHONE: +359 2 902 6666,
FAX: +359 2 902 6660,
office@tesy.com
www.tesy.com

References

• TESY Homepage

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>