ghd NG15 Glide Hot Brush Instruction Manual

: June 14, 2024
: ghd

Table of Contents

Important safety instructions
Operation
User maintenance instructions
Failure to operate
Manufacturer’s guarantee
Recycling and disposal
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Professional hot brush
Instruction Manual

Important safety instructions, manufacturer’s guarantee and how to register your product

Important safety instructions

To reduce the risk of burns, electrocution, fire, or injury to persons, read and follow these safety instructions before using your ghd hot brush.
This ghd hot brush is for use only as a hairstyling aid, and only with products specifically designed for use with a heated hairstyling aid such as a ghd heat mat.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved, by a person responsible for their safety.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
BURN HAZARD: Keep appliance out of reach fromchildren, particularly during use and during cool down after use.
When the appliance is connected to a power supply never leave it unattended.
The ghd hot brush is not suitable for use with synthetic hair. It is possible that colour may permanently transfer onto the hot brush if used on dyed hair.
Warning: keep away from water
Do not use this device in a bathtub, shower, or water filled reservoir.

When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off.
For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30mA is advisable in the electric circuit supplying the bathroom. Ask your installer, or a qualified electrician, for advice.
Do not reach for the for the appliance if it has fallen into water.
Do not spray or apply wet styling aids directly onto the ghd glide™.

Warning: electricity
As with most electrical appliances, electrical parts are electrically live even when the switch is off.
To reduce the risk of electrocution:
Never operate this appliance if it is not working properly, or if it has a damaged power cord or plug. If the power cord or plug is damaged, it must be replaced by Jemella Ltd.

Only use with 220–240V, 50-60 Hz power supply.
The appliance should never be left unattended when plugged in.
Keep the power cord away from heated surfaces. Do not wrap the power cord around the appliance. Do not hang the ghd hot brush by the power cord.
Always unplug the ghd hot brush immediately after using.
Do not use an extension power cord with this appliance.
Do not use a voltage inverter or generator with this appliance.
Your ghd product is a class II electrical appliance and should not be connected to an earth connection.

Warning: hot surfaces
The ghd hot brush heater plate is hot for effective styling.
To reduce the risk of burns:

NEVER touch the heated plate of the hot brush.
When not styling always lay the ghd hot brush on a flat heat-resistant surface such as a ghd hot brush heat mat.
When styling is complete, always switch off the ghd hot brush and unplug it from the power supply.
Wait for the ghd hot brush to cool before storing.
When the ghd hot brush has cooled, fold the power cord in the same way as it was first delivered in its packaging. Do not wind it around your hand or the body of the ghd hot brush as this can lead to early failure of the power cord.

Your ghd glide™ is not only attractive to you, but also to your children. Please ensure you always store your ghd hot brush out of reach of children, particularly during use, especially when cooling.

Operation

Ensure that halr Is completely dry before using the ghd glide™. ghd NG15
Glide Hot Brush - operation

Heaterplate.
On/0ff Switch and indicator light
Povier cord
loniser
Plug your ghd hat brush into the povier supply. The switch sumound wilflash wihite forless than 1 second and beep toindcate tht it s now connected fo mains electriciy. The appliance is row in standby mode.
To tum on the gf hot brush, press and hold the ONDFF button foat least 1 sccond. The gh hot brush wilplay shart start-up tune and a gt wil pulse o indicate that the hot bush is heating up.
IMPORTANT: the gh hot brush heats up quickly, o don’t touch the hot heater britis! Once the ghd hot brush has reached perating temperature, it wil beep and the light wil remain iluminated to indcate tht tis ready touse.
When you have finished your sying session, press and holdthe ON/OFF button for morethan 2 seconds to um the appliance off. A shutdown tune vil playto indicate the appliance has been turned off. Once urned off it i best practice: to unpug the appliance from the mains electicity and allow itto cooln a safe place. For sefe conlng place the appliance on a ghd heatresistant mat and alow 1o cool.

WARNING: while the appllance I cooling down do not touch the heated bristies or allow children or those with reduced physical, ‘sensory or mental capabllites, or lack of experlence and knowiedge to touch the appllance whilst tIs cooling.
the ghd glide™ has the following safety features:

Sleep mode: the ghd hot brush has been lefton and has nat been sed for 60 minutes, a sfety feature wil automatically urn the hat brush off. The ot brush willplay the sleep mode tun, the plte vl start to cool and the: light wil sowy pulse il the plate reaches
a safe temperature Torestartthe applance while in skeep mode, simply tum it on by pressing and holding down the ON/OFF buton for morethan 1 second.
b. Note that athough ohd hot brush i tumed of it s stil connected to the. mains and shouid be unplugged from mains electricity a the eariest opporuniy
Fall saes in the unlkely event of a control system eno,for safety the heatersil of, the gh hot brush will it bleeps and the iht il flash red every fie seconds. I his occurs un-plug and re-piug at the power supply and re-sart. the urit does ot re-stat or theproblem persists, contact ghd Customer Senvie for advice.

User maintenance instructions

Cleaning your ghd gllde™

Unplug the ghd hot brush from the mains power supply.
Always allow the ghd hot brush to coolbefore attempting to clean it
Never immerse the appliance in water
Remove all hair from i betveen the bristes after every usage. Wipe clean any buid-up of syling products with a damp cloth or soft brush (do not scrub) from both bristles and heater plate.
Do not use an abrasive cleaning fiid o clean, as damage willoccur

Storage

Aways allow the ghd hot brush to cool down before storng away.
Wihen the ghd appliance has cooled down, fod the pover cord n the same wayas itwas first defvered in s packaging. Donot wrap the supply cord around the ghd apliance as thiscan strin the cord and cause premature. ‘supply cord falure.

Failure to operate

Fyour product stops vorking and the re fult gt flashes, please folow the procedire below:

Switch of the unit
Unplug the unit from the plug socket
Waitfor 5 secands and then plug the unit back ino the wall
Switch the unit back on

If this occurs repeatedy, please contact your local ghd service centre.
For UK plugs, please ensure that th fitted fuse is intact and functioning; ifitis not, replace it ith an identicall rted Brfish Standard Fuse.
Ifin doubtorfor futher advice, please vistthe help secton of ghahaircom or contact an approved ghd stockistor contact ghd Customer Semvice for further advice.

Manufacturer’s guarantee

All ghd electrical products are individually tested before leaving the factory.
However in the unlikely event of the product proving defective due to faulty workmanship or materials, then, at its sole discretion, ghd will replace the product at no charge with an identical or equivalent product within two years from the original date of purchase. A replacement product assumes the remaining guarantee of the original product or 180 days, whichever provides longer coverage for you. When a product is exchanged, any replacement item becomes your property and the replaced item becomes property of ghd.
To claim under this guarantee please visit ‘ghdhair.com/returns’ and follow the onscreen instructions to complete your return. Please ensure that you include a proof of purchase with any returned product. Therefore please ensure you keep your proof of purchase in a safe place.
This guarantee only applies to genuine ghd products purchased through ghd- approved stockists, and does not cover products repaired or serviced by anyone other than ghd personnel or ghd representatives. Note that this guarantee may be invalidated where serial numbers or identification have been erased, damaged or modified.
This does not affect your statutory rights.

364
*Neither Jemella Group Limited nor its subsidiaries provides
replacement parts for any of its electrical units. If you do not have access to the internet please return your ghd electrical product to the closest ghd address as printed in this leaflet or on the packaging, together with your proof of purchase. For customers in Australia and New Zealand, please phone your closest ghd office on the number printed in this leaflet.
Australia only
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Recycling and disposal

Your ghd electrical product is classified as ‘electrical or electronic equipment and must not be disposed of with other household or commercial waste at the end of its working life. When you have no further use for your ghd product, please dispose of it according to your local authority’s recycling procedure. For more information contact your local authority.
UK/EU only
Your ghd electrical product should be disposed of in accordance with the WEEE directive (Waste Electrical and Electronic Equipment 2002/96/EC), which ensures that products are recycled using the best available methods and practices to minimise any potential damage to the environment. For more information, contact your local authority or the retailer from whom you purchased this product.
Compliance
This ghd hot brush is compliant with BS EN 60335-2-23 and carries the CE mark. Other approvals include the USA, Australia/New Zealand and South Africa.
ghd UK Jemella Ltd
ghd UK: 0845 330 1133
ghd Republic of Ireland: +44 1924 423 400
ghd Returns
Phase 3 (Chilton House)
Sherwood Park
Annesley
Nottingham
NG15 ODJ
UK
ghd South Africa
ghd South Africa: 086 010 9366
ghd South Africa (Pty) Ltd
PO Box 818
Gillitts
3603
South Africa
ghd Australia
ghd Australia: 1300 443 424
Jemella Australia Pty Ltd
PO Box 15516
City East
Queensland 4002
Australia
ghd New Zealand
ghd New Zealand: 0800 880 209
Jemella New Zealand Ltd
ghd New Zealand
Private Bag 211030
Laurence Stevens Drive
Auckland 2154
New Zealand .
Validate your guarantee
For peace of mind styling with your new ghd product, register your guarantee today for:

Verification of the authenticity of your ghd product
Replacement should your ghd product fail within the guarantee period*
Exclusive offers and deals before anyone else
The latest news and trends first

ghd NG15 Glide Hot Brush - QR Code 1 Visit ghdhair.com/register or use your QR reader on your smartphone to validate.
This does not affect your statutory rights.
*conditions apply, see safety instructions

ghd NG15 Glide Hot Brush - Symbols 2 ghdnair.com
9hd and ghd are registered trade marks of Jemella
Group Limied.
© Jemella Group Limited 2021
Designed in Cambridge, UK. Made in China.