AIRCARE EP9 Series Pedestal Evaporative Humidifier Instruction Manual

: June 5, 2024
: AIRCARE

Table of Contents

IMPORTANT SAFETY INSTRUCTIONS READ BEFORE USING YOUR HUMIDIFIER
LET’S GET YOU UP AND RUNNING
ABOUT THE CODES
HOW TO CLEAN YOUR PEDESTAL
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)
1B72081
1B5460070
1B72282
1B72726
1B73364

AIRCARE EP9 Series Pedestal Evaporative Humidifier

IMPORTANT SAFETY INSTRUCTIONS READ BEFORE USING YOUR HUMIDIFIER

WARNING: To reduce the risk of fire, electric shock, or injury, always unplug the unit before moving, filling, servicing, or cleaning. Do not pour or spill water onto the controls or motor area. If these get wet, let them dry completely and have the unit checked by authorized service personnel before plugging in. Do not use the humidifier if any parts are damaged or missing. Contact us for replacement parts at 800.547.3888.

To reduce the risk of fire or shock hazards, this humidifier has a polarized plug (one blade is wider than the other). Plug humidifier directly into a 120V, A.C. electrical outlet. Do not use extension cords. If the plug does not fully fit into the Outlet, reverse plug. If t still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
Keep the electric cord out of traffic areas. lo reduce the risk of fire hazard, never put the electric cord under rugs, near heat registers, radiators, stoves or heaters.
Always unplug the unit before moving, cleaning or removing the fan assembly section from the humidifier, or whenever t is not in service.
Keep the humidifier clean. To reduce the risk of injury, fire or damage to humidifiers, use only cleaners specifically recommended for humidifiers. Never use flammable, combustible or poisonous materials to clean your humidifier
Do not put foreign objects inside the humidifier.
Do not allow unit to be used as a toy. Close attention is necessary when used by or near children.
1o reduce the risk to electrical hazard or damage to a humidifier, do not tilt, jolt or tip the humidifier while unit is running.
To reduce the risk of accidental electrical shock, do not touch the cord or controls with wet hands.
To reduce the risk of fire, do not use near an open flame such as a candle or other flame source.

HUMIDIFIER TWO-YEAR LIMITED WARRANTY POLICY SALES RECEIPT REQUIRED AS PROOF OF PURCHASE FOR ALL WARRANTY CLAIMS
This warranty is extended only to the original purchaser of this humidifier when the unit is installed and used under normal conditions against defects in workmanship and materials as follows:
Two (2) years from date of sale on the unit, and Thirty (30) days on wicks and filters, which are considered disposable components and should be replaced periodically.
The manutacturer will replace the defective part product, at its discretion, with return freight paid by the manufacturer. It is agreed that such replacement is the exclusive remedy available from the manufacturer and that TO THE MAXIMUM EXIENT PERMITTED BY LAW, THE MANUFACTURER IS NOT RESPONSIBLE FOR DAMAGES OF ANY KIND, INCLUDING INCIDENTAL AND CONSEQUENTIAL DAMAGE OR LOSS OF
PROFITS OR REVENUES. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
Warranty Exclusions: we are not responsible for replacement of wiCks and fiters. We are not responsible for any incidental or consequental damage from any maituncton, accident, misuse, alteratons, unauthorized repairs, abuse, incuding allure to pertorm reasonabie maintenance, nofmal wear and teal, nor wnere tie connected votage is more nan So above ue nameplate voltage. we are notresponsioie T0r any dalmage from the use of walter soteners or treatmenis, hemicals or descaling materials. we are not responsibie for tne cost of serice calls to diagnose the cauise of trOUDle, or labor charge to repair and/or replace parts. No employee, agent, dealer or other person is authorized to give any arrantiesor conditions on behalf of the manufacturer. The cUstomer shal be responsible for all labor costs incurred. Some states do not allow the exclusion or limitation of incidental or consequential damages, So the above limitations or xcluisions may not apply to you. Obtaining Warranty Service: Within the limitations of this warranty, purchaser with inoperative units should contact customer service at 800.547.388 for instructions on how to obtain service within arranty as listed above. This warranty gives the customer specific legal rights, and you may also have other rights which vary from province to province, or state to state. Register your productat www.alrcareproducts.com.

LET’S GET YOU UP AND RUNNING

Remove the Pedestal from its packaging.
You should have:
Top
Base
EP9500 #1B71982 | EP9800 #1B72716
1043 Super Wick®
ALL 1043 WICKS
Wick frame

1B72081
Float (taped to the back of your wick frame) #1B71971
Float support and two screws SUPPORT #1B73315 | SCREWS #1B73125
Four casters

1B5460070
Fill door (attached to top) EP9500 #1B71970 | EP9800 #1B72712
Deflector vent (attached to top) EP9500 #1B71973 | EP9800 #1B72714 Funnel

1B72282
Top insert (attached)

1B72726
Owner’s manual

1B73364
Remove everything from the base. Turn the base over and insert the casters snugly into the bottom. Just use your hands! Using tools can crack the base.
Remove the float from the back of the wick frame. Place the wide end of the float in the circular area in the base. Slide the float retainer down to the base and squeeze gently to seat the screw tabs between the pegs. Use a Phillips screwdriver to screw in the float retainer. Do not overtighten or use a drill.
Put your Pedestal base in the most centrally-located room of your home. It should be on a level surface against an interior wall. Make sure it’s at least two inches from the wall so the humidistat (on the cord) can accurately read your humidity.
More about positioning:
- To maximize humidity circulation, put your unit near a cold air return.
- If you prefer to put your unit in the room where humidity is most needed, you can! But the humidity won’t circulate as well with this method.
- Don’t put your humidiﬁer under a window, as condensation may occur.
- Put the unit on the bottom ﬂoor of a multi-story home.
With the wick in the frame, place the frame into the base with the MAX FILL label facing the base’s FRONT label. Fill the base with water. Your Pedestal holds 3.5 gallons of water.
About water additives:
- Do not use essential oils in your Pedestal.
- Do not use water softeners.
- We recommend our Essick Air Bacteriostat to help inhibit mold growth.
  Note: For future reﬁlls, you can either remove the top and ﬁll the base, or use the funnel. To use the funnel, simply slide the pronged end of the funnel into the ﬁll door.
Put the top on the base. Make sure the top of the float rod makes a solid connection with the fan switch inside the fan assembly. This looks like a small, silver diving board.
Wait 20 minutes for the filter to become fully saturated, then proceed to step 8.
Plug in your unit and press the power button.
Set your desired fan level by pressing the fan speed button. Your Pedestal has nine fan speeds that are displayed by F1 (the lowest speed) through F9 (the highest speed).
Note: On higher speeds, the Pedestal puts out a tremendous amount of humidity, so it’s louder on these levels. Most of our customers liken it to the sound of a box fan. Rest assured there is nothing wrong with your unit, it’s just working very hard to put out much-needed humidity.
Press the humidity control button to set your humidity level from 25% to 65%. The humidistat on your cord will read your home’s humidity and turn your fan off when the set level is reached. When set to 65%, your unit will run continuously.
That’s it! Your Pedestal is ready to use.

ABOUT THE CODES

F – The F code means your unit is empty and needs to be FILLED with water.
CF – The CF code triggers after 720 hours of use and means it’s time to CHECK YOUR FILTER (wick). Unplug your unit and check your wick. If your wick is still in good shape, simply clear the code by plugging your humidiﬁer back in. If your wick needs replacing, follow these quick steps:

Remove the wick from the frame by gently squeezing the tabs around the wick frame. Do not discard your frame.
Insert a new 1043 Super Wick® in the frame and snap the frame shut.
Put the wick and frame back into the unit with the MAX FILL label facing the front of the unit.

HOW TO CLEAN YOUR PEDESTAL

Regular cleaning is important for preventing mold, mildew, and other bacterial growth in your humidifier. It also keeps your EP9 working its best.

Let the unit run until it’s empty, then turn it off and unplug it.
Lift the top off the Pedestal, and remove the wick and wick frame from the base.
Throw your wick away if it is time to replace it. Otherwise, remove it from the wick frame (keep your frame) and put the wick in a sink while you ﬁnish cleaning your Pedestal.
Pour out any remaining water from the base.
Fill the base half-full with water and add 1 cup of white vinegar. Let sit for 20 minutes. To disinfect, replace the vinegar with 1 teaspoon of bleach. Do not mix vinegar and bleach.
After 20 minutes, empty the base.
Dampen a sponge with white vinegar, wipe down the base, ﬂoat, and wick frame. Rinse everything thoroughly. To disinfect, replace the vinegar with bleach.
Wipe everything dry. Put your existing wick (or a new one) in the wick frame. Then reassemble the unit.

When storing your Pedestal, discard the used wick (keep your wick frame) and disinfect the unit using the directions above. Dry the unit thoroughly, and store in a temperature-regulated area. Do not install a new wick until you are ready to use your humidiﬁer again.