Teltonika FMC640 4G LTE Cat 1 Truck Tracker With CAN Data Reading Installation Guide
- September 13, 2024
- teltonika
Table of Contents
Teltonika FMC640 4G LTE Cat 1 Truck Tracker With CAN Data Reading
Installation process
- Below is shown main installation location:
- Carefully unscrew the fuse panel screws and fold the panel down.
- Where to find main connector?
- Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
- After installation and device configuration of FMC640 (CAN1 should be selected –FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF – or any other value which is not equal to 0000, means FMS data received also.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>