nous E4 Water Leakage Sensor Instruction Manual
- June 15, 2024
- NOUS
Table of Contents
INSTRUCTION MANUAL
Water Leakage Sensor E4
You will need Nous Smart Home App. Scan the QR code or download it from direct link
https://a.smart321.com/noussmart
Know about the Leakage Sensor
Button(Hiden)
Reset or enter configuration mode: Press and hold the button for 5 seconds
until the blue LED blinks, the device will enter configuration mode
LED
Blinking: The device enters Zigbee network configuration mode(preparing to
connect the gateway)
OFF: The device is under standby status
Quick Installation Guide
Note: Please make sure the gateway is added and on-line before the next step
- (If you have installed the NOUS Smart Home on your mobile phone,please go to step 2) Scan QR code or search NOUS Smart Home in APP Store or Google Play to install APP(new user must register account first).
- Open NOUS Smart Home app, on smart gateway homepage, Click: Zigbee Smart Gateway
- Remove the insulation sheet and press the reset button for 5 seconds, till the blue LED blink, then click “LED already blink” on the app.
- Waiting for a few seconds,you can see the this device is shown and you may rename it.
- lnstall the sensor at the place you need
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>