KUZCO EW37204 Exterior Wall Sconce Installation Guide
- June 3, 2024
- KUZCO
Table of Contents
Installation Guide
INSTALLATION SHEET
EW37204
Exterior Wall Sconce
START FROM HERE
- Make sure the power is completely off at the fuse box.
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area.
- Wear gloves at all times during this installation.
- Read the instructions carefully before you start assembly.
- Keep this instruction sheet for future reference.
Technical Support : +1 855 855 8926
Please Note:
- All Kuzco LED fixtures come with pre-wired LED module(s).
- Unless instructed to do so, please do not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage.
- For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
- Remove the fixture from its original packaging. Remove the mounting plate (1c) from within the fixture (2b) by loosening the screws (2a). Secure the mounting plate (1c) to the junction box (1a) with screws (1d) provided in the hardware package.
- Attach the fixture (2b) to the mounting plate (1c), which is attached to the electrical junction box (1a) on the wall. First, attach all wiring with the provided barrettes (1b) (white to white “N”, black to black “L”, ground to ground “G”). Now attach the fixture (2b) to the mounting plate (1c) with the two screws (2a).
- You have now completed the installation of your fixture, enjoy.
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20190603
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>