KEONJINN B09Q2SYCJG Oval Mirror LED Bathroom Mirror Instruction Manual
- June 5, 2024
- KEONJINN
Table of Contents
KEONJINN B09Q2SYCJG Oval Mirror LED Bathroom Mirror Instruction Manual
WARNING AND SAFETY INSTRUCTIONS
Before assembling your LED Lighted Mirror fixture, please make sure that you carefully read through this instruction sheet, refer back to them during installation to ensure your product is fitted safely and correctly. Keep these instructions for future use.
WARNING Risk of Fire and Electric Shock
- All fittings must be installed in accordance with current IEE wiring regulations. If in doubt, consult a qualified electrician.
- Switch off the electrical supply at the main circuit board BEFORE installation and maintenance.
- Suitable for indoor use only. This product should be positioned well away from curtains and fabrics. Never cover the mirror.
- Regularly check the cord, the transformer and all other parts for damage. If any part is damaged the product should not be used.
INSTALLATION SAFETY
- Inspect the product immediately upon receipt for the transit damage or missing parts. Handle the product with care and protect against knocks to all sides and edges of the glass.
- Ensure there are no hidden pipes or cables in the wall before drilling.
- Wear suitable eye protection when drilling. Take care if drilling on tiled surfaces in case the drill slips.
CAUTION
The light source of this product is non-changeable light diodes (LED). Do not disassemble the product, as the light diodes can cause damage to the eyes.
NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care, are factors that can’ t be built into any product. These factors must be supplied by the person(s) caring for and operating the fixture. Do not install this fixture in hazardous locations.
TOOLS REQUIED
1 Step
Use the tape measure the height, and draw the horizontal line and the vercal
line of the wash-basin.
2 Step
Measure the distance of the mirror hole, and mark the hole place on the wall.
3 Step
Drill and insert the Wall Anchor
4 Step
Drive in the screw cross the boom support.
5 Step
Align the holes of the mirror with the screws and hang them to complete the
installation
Step 11
- We provide plug with mirrors.
- Optional to cut the plug directly and connect to e lectical wiring if using wall switch.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>