KEONJINN EC-BMN-6172 24×32 Inch Oval LED Bathroom Mirror Instruction Manual
- June 5, 2024
- KEONJINN
Table of Contents
KEONJINN EC-BMN-6172 24×32 Inch Oval LED Bathroom Mirror
IMPORTANT SAFETY INSTRUCTIONS
When using electrical furnishing, basic precautions should always be followed, including the following:
- WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer. Never drop or insert any object into any opening.Do not use outdoors.
- WARNING: Risk of electric shock. Connect this furnishing to a properly grounded circuit only. See grounding instructions.
- CAUTION: Maximum shelf load 34Ibs/15.4kg
ELECTRIC CONNECTIONS
ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN.
WARNING:
Shut off power before wiring the cabinet. Requires 120 VAC 20 Amp GFI
protected Circuit.
GROUNDING INSTRUCTIONS:
CAUTION:
This product must be connected to a grounded metal permanent wiring system
or an equipment-grounding conductor must be run with the circuit conductors
and connected to the equipment-grounding terminal or lead on the product.
WARNING:
An Electrical option cabinet must be wired to a 20 Amp GFI (Ground Fault
Interrupter) protected circuit when used in bathrooms and all other locations
required by the National Electric Code.
The electric wire comes through the access hole on the top of the cabinet, the exact location of the access hole varies depending on the product model. Please refer to the actual product for the exact location.
Make connect1on with Junction box. Neutral to white. The line to black. Ground to green.
HARDWARE AND TOOLS
HARDWARE LIST
Installation
Step 1
Level and mark the mirror’s location on the wall. Connect the wire to
Junction Box inside the wall.
Step 2
Use the tape to measure the height, and draw the horizontal, line and the
vertical line of the wash basin. Measure the distance of the mirror hole, and
mark the hole placement on the wall.
Step 3
Drill and insert the Wall Anchor, Drive in the screw across the bottom support.
Step 4
Align the holes of the mirror with the screws and hang them to complete the
installation.
Power On
After power on, the button shows blue and it is in waiting state
- Click the button to make the light gradually dim.
- Click the button again and the light gradually brightens.
After power on, the button shows blue and it is in waiting for the state, lick
to turn on the defogging function and the button turns white. Click again to
turn off the defogging function and the button turn blue.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>