KEONJINN Large Vanity Mirror with Lights Instruction Manual
- June 15, 2024
- KEONJINN
Table of Contents
KEONJINN Large Vanity Mirror with Lights Instruction Manual
INSTALLATION MANUAL
-
Plug
-
Wall Anchors
-
Extra Bulb
-
Screws
-
Phillips Screwdriver
HOW TO USE
-
ON / OFF
Press the button and the bulbs will be gradually lit up to avoid a sudden dazzling light. -
Color Temperature Selection
Press and select the color temperature of the bulb, with three options (warm, natural, cool) available. -
Brightness Adjustment
Press to adjust the brightness of the bulb (five brightness levels to choose), or touch and hold it to switch the
brightness. -
USB Port
Connect and charge smart devices when there is no socket within reach.
Specification
Product Mode | HZ-02A-6456 | HZ-02A-8166 |
---|---|---|
Material | Glass + Aluminum alloy | |
Output Voltage | DC 12V (USB: 5V = 0.5A) | |
Power | 24W | |
Color Temperature | 3000K-6000K | |
LED Bulbs | 15+1 | 18+2 |
Product Size | 64.5×18.8×56.3cm | 81.5×18.8x66cm |
Mirror Size | 64.5×50.4cm | 81.5x60cm |
Installation Instructions: Free Standing
STEP 1
Take out 2 covers from the bottom.
STEP 2
Take out 4 screws from the bases.
STEP 3
Install the two bases with the screws.
STEP 4
Plug LED bulbs into the USB ports on the mirror.
STEP 5
After installing all the bulbs, connect the adapter and turn the mirror on.
NOTE:
- Please plug in all bulbs before powering on.
- Please do not touch the bulb base directly after the mirror is on, in order to avoid possible electric shocks.
- When a bulb needs to be removed, please turn off the mirror first, then hold it tightly and pull it out.
- Do not plug other USB devices into any port on the mirror.
- Do not install the bulb into the USB port of any other devices.
Installation Instructions: Wall-Mounted
TOOLS REQUIRED
-
Level
-
Pencil
-
Hammer
-
Safety Goggles
-
Electric Drill
-
Phillips Screwdriver
-
Tape Measure
STEP 1
Measure the distance between two mounting holes, and draw a horizontal line of
the same distance on the wall with a lever, then mark the spots.
STEP 2
Drill holes at the marked spots and apply the wall anchors.
STEP 3
Slightly loosen the screws from the anchors, with a 7mm gap to the wall. Then
mount the mirror and make sure it’s hang firmly.
NOTE: If you want to attach the mirror to the wall, please put the covers
back after you remove the bases.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>