SubZero SZPA-P12 Portable Speaker User Manual

June 5, 2024
SUBZERO

SZPA-P12 Portable Speaker

SZPA-P12 Portable Speaker
User Manual

WARNING!

  • Do not open the cover. No user-serviceable parts inside. Refer servicing to qualified service personnel Do not place the product in a location near a heat source such as a radiator, or in an area subject to direct sunlight, excessive dust, mechanical vibration, or shock

  • The product must not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the product

  • No naked flame sources, such as lighted candles, should be placed on the product

  • Allow adequate air circulation and avoid obstructing vents (if present) to prevent internal heat build-up.

  • The ventilation must not be impeded by covering the appliance with items such as newspapers, tablecloths, curtains, etc.

  • The mains plug is used to disconnect the appliance from the mains supply. Ensure that the main outlet is easily-accessible and remove the plug from the main outlet if you
    notice any abnormality with the appliance.

  • If used improperly, batteries may explode or leak and cause damage or injury. In the interest of safety:

  • Make sure you observe the correct polarity when replacing batteries

  • Avoid using new batteries together with used ones

  • Avoid mixing different types of batteries

  • Remove batteries if the appliance is to remain unused for an extended period of time

  • Never keep batteries together with metallic objects such as ballpoint pens, necklaces, hairpins, etc.

  • Used batteries must be disposed of in compliance with whatever regulations for their safe disposal that may be observed in the region in which you live.

  • Batteries must not be exposed to excessive heat such as sunshine, fire or the like.

  • The danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.

INTRODUCTION

Thank you for purchasing the SZPA-P12 / SZPA-P15. To get the most out of your product, please read this manual carefully.
BOX CONTENTS

  • 1 x SZPA-P12 / SZPA-P15
  • 2 x Wireless handheld microphones
  • 1 x UK power cable
  • 1 x EU power cable
  • 1 x User manual

FEATURES

  • Powerful battery-operated 12/15” PA system, with media player and 2 mics.
  • 12” speaker produces 60W RMS / 100W Peak / 240W Max.
  • 15” speaker produces 80W RMS / 140W Peak / 320W Max.
  • The digital media player offers Bluetooth, USB, and SD connectivity.
  • Built-in rechargeable battery with up to 6 hours of battery life.

CONTROLS & FUNCTIONS

  1. DIGITAL MEDIA PLAYER
    Enables you to play music through the speaker using a variety of platforms.
    MODE BUTTON
    Change between different input modes (USB, SD, and Bluetooth)
    PLAY/PAUSE BUTTON
    (For USB and SD modes)
    REPEAT BUTTON
    For selecting play and repeat functions
    SKIP
    With short press / SCROLL with a long press
    DISPLAY SCREEN
    SD CARD INPUT
    USB DRIVE INPUT
    BLUETOOTH WIRELESS RECEIVER

  2. MIC GAIN
    Increase and decrease the volume of the microphone inputs (7). Note that this does not control the volume of the wireless microphones.

  3. LINE LEVEL
    Increase and decrease the volume of the line input.

  4. ECHO
    Increase or decrease the amount of echo to be added to the inputs.

  5. MP3 VOLUME
    Increase or decrease the level of the digital media player input.

  6. VOLUME
    Increase or decrease the overall volume of the master output of the speaker.

  7. MIC INPUTS
    2 x TS ¼ jack inputs suitable for low impedance microphone signals. Note, that this input does not support microphones that require phantom power.

  8. LINE INPUTS
    Stereo RCA inputs are suitable for high impedance line-level signals.

  9. MIX OUTPUT
    Stereo RCA output that provides a master output of the speaker’s mix at a line-level signal.

  10. GRAPHIC EQ
    Control the frequencies of the master output at 100Hz, 330Hz, 1KHz, 3.5KHz, and 10KHz. Boost or limit the frequency by +/-12dB.

  11. WIRELESS MICROPHONE VOLUME KNOBS
    control the volume of the wireless microphones. Power to the receiver can be switched on and off using the on/off button.

  12. BATTERY CHARGE INDICATOR
    4 level indicator to show the battery life. The red light indicator flashes when the charge level is below 25%. At this point, you need to recharge the battery as soon as possible to continue use.

  13. &

  14. ANTENNAS
    Receive radio frequency signals from wireless microphones. Be sure these are extended when in use with the wireless microphones.

  15. FUSE
    This fuse is replaceable. Ensure to replace only with a like for like a fuse. Failure to do this could damage the product. Before replacing, remove the unit from any external power supply and ensure the main plug is not attached.

  16. MAINS CONNECTION
    Use only the power cable supplied with the product. This power socket is fitted with an F1A at 250V fuse. Ensure to replace only with a like for like a fuse. Failure to do this could damage the product. Before replacing, remove the unit from any external power supply and ensure the main plug is not attached.

  17. POWER SWITCH
    This turns the device on and off. Note, if the power switch is off but still connected to a mains connection, the battery will continue to charge.

WIRELESS MICROPHONE

  1. GRILL
    This protects the microphone from damage. Do not take the grill off, as there are no user-serviceable parts inside.

  2. LED
    This light flashes once turned on and then will not light again under normal conditions. If the battery is low, the LED will flash.

  3. ON/OFF SWITCH
    This has three positions. Off at the bottom, mute in the middle (RF signal is operative but the audio is muted), and one at the top.

  4. BATTERY COMPARTMENT
    This requires 2 x AA batteries (1.5v each). Do not use any other kind of battery with this microphone.

  5. BATTERY COVER
    To remove, push the top of the door slightly and slide downwards. The opposite is applicable to reinsert.

USING THE MEDIA PLAYER

  1. USB INPUT
    Allows you to play any .mp3, .wma or .wav files.

  2. SD CARD INPUT
    Allows you to play any .mp3, .wma or .wav files.

  3. LCD DISPLAY
    Shows you all the functions that are currently being used.

  4. REMOTE CONTROL SENSOR
    (controller not included in this model)

  5. MODE SELECT BUTTON
    Cycle between Bluetooth, SD, and USB connections.

  6. PLAY/PAUSE
    Allow you to play and pause the audio.

  7. STOP
    Allow you to stop the audio

  8. LOOP
    Allow you to loop the current audio track (SD card and USB only). Pressing repeatedly allows you to change between looping current songs, repeating all songs in the particular folder, loop playback of all songs in all folders, and random playback.

  9. SKIP BACK
    Go back one track (short press), or rewind (long press).

  10. SKIP FORWARD
    Go forward one track (short press), or fast forward (long press).

BLUETOOTH CONNECTION
To connect a Bluetooth device to the speaker digital media player, please follow the below steps.

  • Ensure that the speaker is powered on and within range of the Bluetooth device.
  • Press the MODE button on the speaker’s digital media player until ‘Bluetooth’ is displayed on the screen.
  • Open the Bluetooth settings on the Bluetooth-enabled device.
  • Scan for Bluetooth devices and search for ‘SZPA-P12’ or ‘SZPA-P15’ in the devices list.
  • Select ‘SZPA-P12’ or ‘SZPA-P15’. The Bluetooth-enabled device should confirm that it is now connected.
  • Play audio from the Bluetooth-enabled device, ensuring that the volume is turned up.
  • Turn up the MP3 VOL dial on the speaker to the required level.

WIRELESS MICROPHONE INFO

This product fully complies with all relevant standards in the Radio Equipment Directive (RED) 2014/53/EU. A full declaration of conformity is available at info@gear4music.com.
Please see the map for information about the use of the included wireless microphone in your region. More information can be obtained at info@gear4music.com or by contacting your local authority.
We want you to be completely satisfied with your purchase. Should you have any questions or queries about this product, contact the Gear4music hotline at
+44 (0)330 365 4444 or at info@gear4music.com

SPECIFICATIONS

SZPA-P12 SZPA-P15
Speaker Size 12″ + 1″ Compression Driver

Driver
Amplifier Class| Class AB| Amplifier Class| Class AB
Output Power| 60W RMS 85W PEAK 240W MAX| Output Power| 80W RMS
115W PEAK 320W MAX
Frequency Response| 68Hz – 19KHz| Frequency Response| 68Hz – 19KHz
Max SPL| 109dB| Max SPL| 112dB
Protection Circuits| Short Circuit, Overcurrent| Protection Circuits| Short Circuit, Overcurrent
Supported Media Platforms| Bluetooth, USB, SD| Supported Media Platforms| Bluetooth, USB, SD
Input Channels| 2 x ‘A” Jack Mic-in, 1 x
stereo RCA line in| Input Channels| 2 x ‘A” Jack Mic-in, 1 x stereo RCA line in
Output Channels| 1 x stereo RCA| Output Channels| 1 x stereo RCA
Wireless Microphone Frequency| 863.1 + 864.5MHz| Wireless Microphone Frequency| 863.1 + 864.5MHz
Max RF Power| 10mW| Max RF Power| 10mW
Mic Frequency Response| 50Hz – 17KHz| Mic Frequency Response| 50Hz – 17KHz
Mains Power| 230V at 50HzAC IEC cable| Mains Power| 230V at 50HzAC IEC cable
Mains Fuse Type| T1A, 250V| Mains Fuse Type| T1A, 250V
Battery Fuse Type| T10A, 250V| Battery Fuse Type| T10A, 250V
Power Consumption| 56W| Power Consumption| 56W
Battery Life| Up to 4 hours| Battery Life| Up to 4 hours
Weight| 12.2Kg| Weight| 17.2Kg
Dimensions| 420 x 645 x 345mm| Dimensions| 485 x 690 x 345mm

KETTLESTRING LANE
YORK
YO30 4XF
UNITED KINGDOM
If you have any more questions about this product, please do not hesitate to contact the Gear4music
Customer Service Team on:
+44 (0) 330 365 4444
or info@gear4music.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals