SubZero H100BT Wireless Bluetooth Headphones User Manual

SubZero H100BT Wireless Bluetooth Headphones

IMPORTANT  INSTRUCTION

WARNING!

• Do not open cover. No user-serviceable parts inside. Refer servicing to qualified service personnel
• Do not place the product in a location near a heat source such as a radiator, or in an area subject to direct sunlight, excessive dust, mechanical vibration or shock
• The product must not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the product
• No naked flame sources, such as lighted candles, should be placed on the product
• Allow adequate air circulation and avoid obstructing vents (if present) to prevent internal heat build-up. The ventillation must not be impeded by covering the appliance with items such as newspapers, table-cloths, curtains etc.

INTRODUCTION

Thank you for purchasing the SubZero H100BT Wireless Bluetooth Headphones. To get the most out of your product, please read this manual carefully.

BOX CONTENTS

•  1 x SubZero H100BT wireless
• Bluetooth headphones
•  1 x USB charging cable
•  1 x 3.5mm TRS Jack cable
•  1 x User Manual

FEATURES

•  Up To 6 hours of wireless listening time.
•  Foldable design, ideal for travelling.
•  Skip tracks, answer calls, and adjust volume wirelessly.
•  Rechargeable via USB.
•  Also suitable for wired use.

FUNCTIONS

• PREVIOUS TRACK / VOLUME INCREASE
  •  Use this button to either skip to the previous track (press and hold), or increase the volume (quick press).
• NEXT TRACK / VOLUME DECREASE
  • Use this button to either skip to the next track
  •  (press and hold), or decrease the volume (quick press).
•  PLAY / PAUSE / MUTE
  •  Use this button to either play or pause the current track (quick press) or mute the headphones (press and hold).
•  MULTIFUNCTION BUTTON
  • POWER: Press and hold this button to power on or off the headphones.
  • BLUETOOTH ON/OFF: When Bluetooth is off, press and hold the button until the LED quickly flashes between red and blue. When Bluetooth is on, firstly ensure no audio is being emitted through the headphones, then press and hold the button until you hear a descending tone.
•  ANSWER/END CALL: When a phone call comes  in, short press the button to answer it, or long press for 2 seconds to reject the call. To end a call, short press the button again.

5MM TRS JACK CONNECTION

Connect a 3.5mm jack cable here to use the headphones without Bluetooth. The headphones do not require to be powered on for use with 3.5mm Jack cables.

USB CHARGING CONNECTION

Connect the USB charging cable here to recharge the headphone batteries.

LED

•  Used to indicate the current state of the headphones.
  • Blue, solid: Power on.
  • Red/Blue, flashing quickly: Pairing mode active.
  • Blue, flashing slowly: Headphones are paired.
  • Red, solid: Charging in progress.
  • Red, flashing: Low battery.

MICROPHONE
Used to pick up your voice when making and receiving calls.

FUNCTIONS BLUETOOTH

• To pair the headphones to a Bluetooth enables device, please follow the below instructions.
•  Press and hold the power button (4) until the LED flashes quickly between red and blue.
•  Enable Bluetooth pairing on your Bluetooth device.
•  Search for ‘SubZero’ in the Bluetooth device list and select.
•  When the headphones are connected you will hear a beep sound and the LED will slowly flash blue.
• The headphones will now automatically pair with the device for all subsequent uses, however automatic pairing will only work with the most recently paired device.
• If pairing is not completed within 3 minutes the headphones will automatically switch off.
• For use with the 3.5mm cable, the headphones are not required to be turned on or paired to a device.

MAKING AND RECEIVING CALLS

To make and receive calls once the headphones are paired with a Bluetooth- enabled mobile phone, please follow the below instructions.

MAKING A CALL

Use your mobile phone to make a call as normal.The call audio will be directed through theheadphones and your voice will be picked by thebuilt-in microphone (8).

RECEIVING A CALL

When a call is being received, you will here a voicethrough the headphones informing you that thereis a call waiting. To answer the call quick press theanswer/reject call button (4), or to reject the callpress and hold the answer/reject call button. To enda call, quick press the answer/reject call button.

CHARGING

• The SubZero H100BT contains a built-in rechargeable battery. The first time the headphones are used they will require 4 hours of charging time.
• All subsequent charges will require between 2 and 3 hours.
• The LED will turn solid red when charging is in progress and will return to solid blue once fully charged.
• When the battery is low, the LED will flash red and beep twice every 10 seconds until the device shuts down.

SPECIFICATIONS

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>