SubZero SZ-AI2 USB Audio Interface User Manual

June 5, 2024
SUBZERO

SubZero SZ-AI2 USB Audio Interface

SubZero-SZ-AI2-USB-Audio-Interface-
PRODUCT

WARNING!

Do not open cover. No user-serviceable parts inside. Refer servicing to qualified service personnel Do not place the product in a location near a heat source such as a radiator, or in an area subject to direct sunlight, excessive dust, mechanical vibration or shock The product must not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the product No naked flame sources, such as lighted candles, should be placed on the product Allow adequate air circulation and avoid obstructing vents (if present) to prevent internal heat build-up. The ventilation must not be impeded by covering the appliance with items such as newspapers, tablecloths, curtains etc.

INTRODUCTION

Thank you for purchasing the SubZero AI2 USB Audio Interface. To get the most out of your product, please read this manual carefully.

CONTENTS4

  •  1 x SubZero AI2 USB Audio Interface
  •  1 x USB cable
  •  1 x User manual

FEATURES

  •  Bus-powered interface with two combi-jack studio-grade preamps.
  •  Record where you like, however you like via USB power.
  •  Incredibly easy to use – no installation drivers are required!
  •  Provides 24-bit 96kHz recording possibilities.

FUNCTIONS

FRONT PANEL

  1.  MIC 1
    Use this input to connect XLR /TRS devices such as microphones and line level instruments.

  2.  GAIN 1
    Use this to increase/decrease the amount of gain on the MIC 1 input.

  3.  INS 1
    Use this button to switch between high (line level) and low (microphones) impedance on the MIC1 input.

  4.  MIC 2
    Use this input to connect XLR /TRS devices such as microphones and line-level instruments.

  5.  GAIN 2
    Use this to increase/decrease the amount of gain on the MIC 2 input.

  6.  INS 2
    Use this button to switch between high (line-level) and low (microphones) impedance on the MIC1 input.

  7.  +48v
    Use this button to apply phantom power when connecting a condenser microphone.

  8.  MONITOR
    Adjust these buttons to switch between stereo/ mono monitoring.

  9.  MASTER
    Adjust this switch to control the master output volume.

  10.  HEADPHONE GAIN
    Adjust this knob to control the headphone volume output.

  11.  HEADPHONE OUTPUT
    Use this output to connect your headphones here. REAR PANEL

  12.  LEFT OUT / RIGHT OUT
    Use these balanced XLR outputs to connect the AI2 to either studio monitors, an amplifier, or an external mixing desk.

  13.  LOCK CONNECTOR
    Use this to connect the AI2 to a laptop lock connector to prevent the unit from being stolen.

  14.  USB
    Use this port to connect the AI2 to your computer via the supplied USB cable.

SPECIFICATIONS

SubZero-SZ-AI2-USB-Audio-Interface-
FIG-2

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals