KEMIMOTO BZH0224-02 Adjustable Side Mirror Installation Guide

KEMIMOTO BZH0224-02 Adjustable Side Mirror

BEFORE YOU BEGIN

1. Read these instructions and check to be sure all parts and tools are accounted for
2. Please retain these install action instructions for future reference and parts ordering information.

IMPORTANT

1. Please read the installation instructions carefully before you start.
2. F the vehicle is clean and free of other debris. it will be easy to install.
3. For your safety and to ensure a satisfactory installation. please complete all the installation steps in the order shown below

PRODUCT INFORMATION:

1. Lens R800
2. Lens R1200
3. Mirror case
4. Mirror harness (female connector)
5. Plain bearing
6. Hexagon socket head screw M6″ L30
7. Pipe clamp-1
8. Hexagon socket head screw M6″ L22
9. Metal spring washer Mô
10. Hexagon socket head screw M6°L40
11. Metal gasket M6’D18″1.2
12. Connecting rod-1
13. POM ball head
14. Pipe lamp-2
15.  Lock nut M
16. Bracket-1
17. Hexagon socket head screw M5’L10
18. Gray lampshade (left and right) x2
19. Gray lampshade (middle) x2
20. Bluetooth controller 4
21. Extension harness K2

INSTALLATION TIPS:

1. Install the mirror parts B9114 on roll cage in order, and tighten the screws [8] (fg. 1). The effect after installation (Fig. 2).
2. Repeat step 1 to install the other side.
3. Connect the mirror harness. extension harness 21]. Bluetooth controller [20] and vehicle power by following the wiring diagram shown above.
4. Scan the QR code on the controller [20], download the control APP, then open the APP and connect to Bluetooth to control the RGB lights.

FUNCTION DESCRIPTION:

FCC

FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and o n, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>