KEMIMOTO B1406-05501SL Golf Cart Aluminum Battery Tray Installation Guide
- May 15, 2024
- KEMIMOTO
Table of Contents
Complete journey of dreams
PRODUCT MANUAL
SKU: B1406-05501SL
BEFORE YOU BEGIN
- Please read the instructions carefully and verify that each item is in the list.
- Please retain these installation instructions for further reference and parts ordering information.
PRODUCT INFORMATION
1. Battery Holder B(R) | x1 |
---|---|
2. Battery Holder A | x2 |
3. Battery Holder C | x1 |
4. Battery Holder D | x1 |
5. Battery Holder E | x1 |
6. Battery Holder F | x2 |
7. Battery Holder B(L) | x1 |
8. M8x25mm Countersunk Hexagon Socket Screw | x8 |
9. M8x30mm Countersunk Hexagon Socket Screw | x4 |
10. M8 Flange Anti-loose Nut | x16 |
11. M8x25mm External Hexagon Flange Face Bolt | x4 |
12. M8 Hexagon Wrench | x1 |
13. Open-end Wrench | x2 |
Estimated installation time: 20 minutes
IMPORTANT
- Please read the installation instructions carefully before you start.
- If the vehicle is clean and free of other debris, it will be easy to install.
- For your safety and to ensure a satisfactory installation, please complete all the installation steps in the order shown below.
INSTALLATION TIPS
STEP1: Lift up the
seat cushion to reveal the battery compartmentDisconnect the power and remove
the battery, placing it aside.STEP2: Use a cutting machine to saw off the original
battery bracket [A], and grind the welding marks smooth (pay attention to safe
operation).STEP3: Loosen the original screws at [a], remove the
original screws at [b] and [c] (keep them aside), and remove the original
battery bracket B.STEP4: Install
[2], fix it with the original screw at [c], and tighten the original screw at
[b].STEP5: Install [6] and fix
it with [11] and [10]. (The small square of [6] faces up)STEP6: Assemble [1], [4], and [7] with [8] and
[10].STEP7: Fix the assembled
[1], [4], and [7] in the position shown in the diagram with [11] and
[10].STEP8: Install [5] as shown
in the diagram.STEP9: Install [3]
as shown in the diagram. STEP10: Pass the vehicle electric cable through the
position shown in [4].
STEP11: Install the battery into the installed battery bracket, connect the
wiring harness, and install the seat cushion.
STEP12: Installation is complete.
Installation Renderings
www.kemimoto.com
Designed by Kemimoto Group
2023 Kemimoto All Rights Reserved
Infringement must be prosecuted.K K K