KEMIMOTO B1709-01101BK In Bed Gun Boot Mount Bracket for UTV User Manual
- June 1, 2024
- KEMIMOTO
Table of Contents
KEMIMOTO B1709-01101BK In Bed Gun Boot Mount Bracket for UTV
Product Information
SKU: B1709-01101BK
Estimated installation time: 30 minutes
- Bracket A
- Bracket B
- Bracket C
- Bracket D (pre-bonded with 10mm thickness EVA adhesive)
- Bracket D- (pre-bonded with 10mm thickness EVA adhesive, pre-installed)
- Bracket E
- Bracket F
- M8 nut
- Expansion anchor
- EVA adhesive (thickness 5mm)
- M6 hexagon wrench
- M8 hexagon wrench
Installation Tips
- Use two screws to assemble and tighten the components installed in the first and second steps.
- Use two nuts to install bracket F on bracket B, adjust bracket F to the appropriate position, and do not tighten nuts.
FAQ
-
Q: How long does it take to install the product?
A: The estimated installation time is 30 minutes. -
Q: Can the product be installed in different locations on the vehicle?
A: Yes, there are two installation methods provided in the user manual for installing the product in different positions on the rear cargo bed.
Complete journey of dreams
PRODUCT MANUAL
SKU: B1709-01101BK
BEFORE YOU BEGIN
- Please read the instructions carefully and verify that each item is in the list.
- Please retain these installation instructions for further reference and parts ordering information.
PRODUCT INFORMATION
IMPORTANT
- Please read the installation instructions carefully before you start.
- If the vehicle is clean and free of other debris, it will be easy to install.
- For your safety and to ensure a satisfactory installation, please complete all the installation steps in the order shown below.
Estimated installation time: 30 minutes
- Bracket A × 1
- Bracket B × 1
- Bracket C × 1
- Bracket D(pre-bonded with 10mm thickness EVA adhesive) × 1
- Bracket D-(pre-bonded with 10mm thickness EVA adhesive, pre-installed anti-slip webbing × 1 + Japanese buckle × 1) × 1
- Bracket E × 1
- Bracket F × 1
- M6 × 14mm flat head bolt × 2
- M8 nut × 2
- Expansion anchor × 2
- EVA adhesive (thickness 5mm) × 2
- M6 × 45mm screw × 5
- M8 × 100mm screw × 2
- ST6 × 15mm self-tapping screw × 3
- M6 hexagon wrench × 1
- M8 hexagon wrench × 1
TWO INSTALLATION METHODS
Note: When installing the Kolpin Stronghold®Tool Boot® model, it is necessary to tear off the pre-bonded 10mm EVA adhesive on brackets D [4] and D- [5] , then replace with 5mm EVA adhesive[11].
INSTALLATION TIPS
Method 1: Install in the right-angled edge of rear cargo bed
Method 2: Install in the middle of the rear cargo bed
www.kemimoto.com K Designed by Kemimoto Group K Kemimoto All Rights Reserved, Infringement must be prosecuted.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>