KEMIMOTO B1406-04101BK Universal Golf Cart Rear View Mirror Instruction Manual
- May 15, 2024
- KEMIMOTO
Table of Contents
KEMIMOTO B1406-04101BK Universal Golf Cart Rear View Mirror
Product Information
Specifications
- SKU: B1406-04101BK
- Function: Center Mirror
- Parts Included:
- Center Mirror x1
- Metal Bracket x2
- Thumb Screw x2
- Metal Washer x2
- Rubber Washer x2
- Lock Nut x2
- Self-tapping Screw x4
- Allen Wrench x1
- Open End Wrench x1
Product Usage Instructions
Before You Begin
- Read the instructions and check all parts and tools.
- Retain installation instructions for future reference.
Installation Steps
Step 1: Mirror Placement
- Choose the hole on the mirror based on your need.
- Place metal brackets against the front inner side of the roof panel.
Step 2: Bracket Installation
- Install two metal brackets to the mirror using parts [3,4,5,6].
- Secure the metal brackets with four self-tapping screws on the roof panel.
FAQ
-
Q: What should I do if the mirror is not stable after installation?
A: Check if all screws are tightened securely. If instability persists, recheck the installation steps and ensure proper alignment. -
Q: Can the mirror be adjusted once installed?
A: Yes, you can adjust the mirror by loosening the screws marked [A] and moving the metal plates left or right as needed.
Complete journey of dreams
PRODUCT MANUAL
SKU : B1406-04101BK
BEFORE YOU BEGIN
- Read these instructions and check to be sure all parts and tools are accounted for.
- Please retain these installation instructions for future reference and parts ordering information.
IMPORTANT
- Please read the installation instructions carefully before you start.
- If the vehicle is clean and free of other debris, it will be easy to install.
- For your safety and to ensure a satisfactory installation, please complete all the installation steps in the order shown below.
PRODUCT INFORMATION
- Center Mirror
- Metal Bracket
- Thumb Screw
- Metal Washer
- Rubber Washer
- Lock Nut
- Self-tapping
- Screw Allen
- Wrench Open
- End Wrench
FUNCTION
- Loosen four screws [A], the two metal plates can be adjusted left and right.
- Loosen two thumb screws [3], the mirror [1] can be swung up and down 180°.
INSTALLATION TIPS
STEP 1
Install two metal brackets [2] to the mirror [1] with parts [3,4,5,6].
STEP 2
Place the metal brackets [2] against the front inner side of the roof panel, secure them with four self-tapping screws [7].
- www.kemimoto.com
- Designed by Kemimoto Group (K) Kemimoto
- All Rights Reserved, Infringement must be prosecuted.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>