NEMO STUDIO LUX W- D Outdoor Spot Instruction Manual
- June 5, 2024
- NEMO STUDIO
Table of Contents
STUDIO LUX W- D Outdoor Spot
Instruction Manual
Box contents
Installation
Installation should be carried out by a suitable quality installer.
Make the wiring using a system that guarantees at least the IP grade of
the spot.
****Connect the fitting to the power supply only after connecting all LEDs to
the driver
Remove the 3 fixing screws of the base.
Remove the base in order to fix it to the wall with wall dowels (not included).
After calculating the distance, make 2 holes in the wall and insert the 2
rawlplugs and appropriate screws. Connect the lamp to the primary circuit
(230V) through the clamp on the driver (included).
Once the base is fixed, fit the luminaire to the base blocking it with the no
head screws.
Put the network cable in the heat (shorten it if necessary) and secure it to
the driver.
Example of connection ( parallel connection)
CAUTION
OUTDOOR LUMINAIRE
Installation should be carried out by a suitable quality installer./Disconnect
main voltage before maintenance operation / All wiring and maintenance must be
performed with the main switch in the OFF position/Don’t open the luminaire.
Connect the fitting to the power supply only after connecting all LED to the
driver (when expected)/In case of failure, upon a return authorization of NEMO
Studio, the product will be not either open or dismounted and the cable must
be cut leaving at least 10/15cm/Make the wiring using a system that guarantees
at least the IP grade of the spot.
Se previsto, use only bulbs of a suitable type and power specified in the
label/Do not install fixture in an environment with the presence of chlorine,
salt air, or aggressive agents, if not expressly mentioned./The color
temperature (CCT) of LED sources can be different from the declared nominal
value within a range of ±5%. / NEMO reserves the
right to make any technical or formal alterations to its products without
giving prior notice, especially for LED sources./We recommend you to keep
instructions for further consultations.
For a proper operation, the fitting requires its protective undamaged glass.
Lamping
This luminaire contains built-in LED lamps.
The LED and the cables cannot be changed in the luminaire from the end-user.
Please contact NEMO STUDIO (the only authorized center).
This product contains a light source of energy efficiency class
Don’t look directly at the light source
NEMO Studio
Ilti Luce Srl – Strada Borgata Paradiso 20 – 10036 Settimo Torinese (TO) ITALY
Tel +39 011 7657301
nemostudio@nemolighting.com –
nemolighting.com
Copyright © 2020 NEMO Srl Milano, Italia.
The text and images are protected by copyright.
Unauthorized reproduction.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>