NEMO STUDIO LUX SURFACE Floor Mounted Light Instruction Manual
- June 5, 2024
- NEMO STUDIO
Table of Contents
NEMO STUDIO LUX SURFACE Floor Mounted Light
Box contents
Installation
- the terminal block not included
- Connect the fitting to the power supply only after connecting all LED to the driver
- Installation should be carried out by a suitable qualified installer.
- Make the wiring using a system that guarantees at least the IP grade of the spot.
- Unscrew the 3 fixing no head screws of the base.
- Remove the base in order to fix it to the wall.
- After calculating the distance, make 2 holes in the wall
- Insert the 2 rawlplugs and proper screws (not included) using oring and washer as indicated in the pictures above.
- Connect the lamp to the primary circuit (230V) through the internal appropriate connection box Class II (included).
- Put the network cable in the sheat (shorten it if necessary) and secure it to the terminal.
- Once the base is fixed, fit the luminaire to the base block-ing it with the no head screws.
Example of connection (parallel connection)
CAUTION
OUTDOOR LUMINAIRE Installation should be carried out by a suitable qualified
installer. / Disconnect main voltage before maintenance operation / All wiring
and maintenance must be performed with the main switch in the OFF position /
Don’t open the luminaire. Connect the fitting to the power supply only after
connecting all LED to the driver (when expected) / In case of failure, upon a
return authorization of NEMO Studio, the product will be not either open or
dismounted and the cable must be cut leaving at least 10/15cm / Make the
wiring using a system that guarantees at least the IP grade of the spot. / Se
previsto, use only bulbs of a suitable type and power specified in the label /
Do not install fixture in an environment with the presence of chlorine, salt
air or aggressive agents, if not expressly mentioned. / The color temperature
(CCT) of LED sources can be different from the declared nominal value within a
range of ±5%. / NEMO reserves the right to make any technical or formal
alterations to its products without giving prior notice, especially for LED
sources. / We recommend you to keep instructions for further consultations.
- For a proper operation, the fitting requires its protective undamaged glass.
Lamping
- This luminaire contains built-in LED lamps.
- The LED, the cables and the driver cannot be changed in the luminaire from the end-user.Please contact NEMO STUDIO (only authorized center).
- This product contains a light source of energy efficiency class
NEMO Studio
Ilti Luce Srl – Strada Borgata Paradiso 20 – 10036 Settimo Torinese (TO) ITALY Tel +39 011 7657301 [email protected] – nemolighting.com Copyright © 2020 NEMO Srl Milano, Italia. The text and images are protected by copyright. Unauthorized reproduction.