ENFORCER SM-4201-LQ Track-Mount OverheadDoor Magnetic Contacts User Manual
- June 5, 2024
- ENFORCER
Table of Contents
Track-Mount OverheadDoor Magnetic Contacts
SM-4201-LQ, SM-4201-L3Q, SM-4201-L6Q
Manual
SM-4201-LQ shown
Track-Mount OverheadDoor Magnetic Contacts
-
3″ (76mm) Gap for overhead doors in both industrial and residential situations
-
Rugged aluminum housing
-
36″ (91cm) Wire leads enclosed in armored cable
-
The contact reed switch is iridium-plated to have a high melting point and Vickers hardness for higher power handling and longer expected life
-
Models available for:
SPST closed loop circuits (SM-4201-LQ), -
SPDT open/closed loop circuits (SM-4201-L3Q), or DPDT open/closed loop circuits (SM-4201-L6Q)
-
Mounting brackets included
-
Adjustable for door-channel widths from 2~21/2″ (51~64 mm)
-
Lifetime limited warranty
Optional Accessory -SM8201LWQ
L-bracket for door channels up to 4″ (102mm)
Parts List
1x Contact switch
1x Contact bracket
1x Magnet with bracket
1x Manual
Specifications
| Model | SM-4201-LQ | SM-4201-L3Q | SM-4201-L6Q |
|---|---|---|---|
| Loop type | Closed | Open/Closed | Open/Closed |
| Electrical configuration | N.O. (SPST) | NO/NC (SPDT) | NO/NC (DPDT) |
| Operation gap | 3″ (76mm) | ||
| Connectors | 36″ (91cm) Armored leads | ||
| Switch Material | Aluminum | ||
| Contacts | Iridium-plated | ||
| Contact rating | 1.0A@10VDC (max.) |
10W (max.)
Operating temperature| -150-160° F (-25°-70° C)
Switch cycles| 50 Million (0.1mA@5VDC)
Dimensions Switch| 31/8″x25/8″x113/16″ (79x66x46 mm)
Magnet| 31/4×39/16×13/4″ (82x90x44 mm)
Magnet type| Ferrite
Overview
- Contact and magnet must be installed on the protected side of the door.
- The installation shown is for the SM-4201-LQ. Other models will be different. Alarm Control GND Panel N.O.
Installation
Please read the manual carefully before you begin the installation.
- Mount the contact on the track in a safe location away from equipment interference and near where the magnet will be when the door is closed.
- Run the armored cable out of the way. Run wires from the alarm control panel and connect to the corresponding wires extending from the cable armor.
- Mount the magnet on the roll-up door so that it will trigger the contact when the door is closed. Be sure that the gap between the contact and magnet does not exceed 3″ (60mm).
California Proposition 65 Warning : These products may contain chemicals
that are known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
LIMITED LIFETIME WARRANTY: This SECO-LARM product is warranted against
defects in material and workmanship while used in normal service for the
lifetime of the product. SECO-LARM’s obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation
prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be responsible
for any costs or charges for removal, installation, or reinstallation. This
Warranty is void if the damage is caused by or attributed to acts of God,
physical or electrical misuse or abuse, neglect, repair, or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason
SECO-LARM determines that such equipment is not operating properly as a result
of causes other than defects in material and workmanship. The sole obligation
of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to repair
or replacement only, at SECO-LARM’s option. In no event shall SECO-LARM be
liable for any special, collateral, incidental, or consequential personal or
property damages of any kind to the purchaser or anyone else. This lifetime
limited warranty is for products sold and installed in the United States and
Canada. For all other countries, the warranty is 1 (one) year.
NOTICE: The SECO-LARM policy is one of continual development and
improvement. For that reason, SECO-LARM reserves the right to change
specifications without notice. SECO-LARM is also not responsible for
misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their
respective owners. Copyright © 2022 SECO-LARM U.S.A., Inc. All rights
reserved.
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Phone: 949-261-2999
800-662-0800
Website: www.seco-larm.com
Email: sales@seco-larm.com
PICNN1
MI_SM-4201-LxQ_220112_ML
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>