ENFORCER SM-433-TQ-W Concealed-Terminal Adhesive Surface-Mount Contacts User Manual
- June 5, 2024
- ENFORCER
Table of Contents
ENFORCER SM-433-TQ-W Concealed-Terminal Adhesive Surface-Mount Contacts
INTRODUCTION
- Surface-mount adhesive magnetic contacts
- Gold-plated terminals for longer expected life and reliability
- Contact reed switch is SPST, iridium-plated to have a high melting point and Vickers hardness for higher power handling and longer expected life
- Concealed screw terminals
- Cover hides mounting screws, terminal block, and wires
- For closed loop circuits
- 11/4″ (31mm) Gap
- Double-sided mounting tape included
- Lifetime limited warranty
Parts List
- 10x Contact switches
- 1x Manual
- 10x Magnets
Specifications
| Model | SM-433- TQ/W | SM-433- TQ/B |
|---|---|---|
| Loop type | Closed loop | |
| Electrical configuration | N.O. (SPST) | |
| Operation gap | 11/4″ (31mm) | |
| Connectors | Gold-plated screw terminals | |
| Housing color | White | Brown |
| Mounting | Adhesive tape | |
| Material | Case | High-impact ABS plastic |
| Contacts | Iridium plated | |
| Contact rating | 1.0A@10VDC (max.) |
10W (max.)
Operating temperature| -15°~160° F (-25°~70° C)
Switch cycles| 50 Million (0.1mA@5VDC)
Dimensions| Switch| 2″x9/16″x1/2″ (51x14x13 mm)
Magnet| 2″x9/16″x1/2″ (51x14x13 mm)
Magnet type| Rare-earth neodymium
Overview
Protected side of the door/window.
Installation
Please read the manual carefully before you begin the installation.
- Mount the contact above the door or window on the frame. For doors, ensure that the mounting is farthest from the hinged side of the door.
- Connect two wires between the two terminals and the alarm control panel.
- Mount the magnet on the door/window so that it will face the contact. Be sure that the gap between the contact and magnet does not exceed 11/4″ (31mm).
California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
LIMITED LIFETIME WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be responsible for any costs or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited warranty is for products sold and installed in the United States and Canada. For all other countries the warranty is 1 (one) year.
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2022 SECO-LARM U.S.A., Inc. All rights reserved.
Website: www.seco-larm.com
Email: sales@seco-larm.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>