signify LIGHTOLIER MS Series 3D Printed Lighting Track Heads Instruction Manual
- June 3, 2024
- signify
Table of Contents
3D printed lighting
MS Series
Track Heads
Read and understand these instructions before proceeding.
This fixture is intended for installation in accordance with the National Electrical Code and Local Regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding. Allow fixture to cool before handling.
INSTRUCTIONS FOR ATTACHING TO SINGLE CIRCUIT TRACK SYSTEM
1. Insert into TRACK (see Fig 1). LOCKING LEVER must be on the same side of
track as BEAD.
2. Rotate FITTING 90° Clockwise (see Fig 2)
3. Rotate FITTING until LOCKING LEVER snaps and locks in place (Fig 3).
4. To remove: depress LOCKING LEVER, then rotate FITTING 90° Counterclockwise
Figures 1a-3a:
Lightolier Adapter
Figures 1b-3b:
Halo Adapter
Figures 1c-3c:
Juno Adapter
INSTRUCTIONS FOR CONVERTING ATTACHEMENT FITTING TO OPERATE ON 2 CIRCUIT
TRACK
To convert attachment FITTING to upper circuit of 2 circuit track, raise BRASS CONTACT to high position by lifting CONTACT as high as stop permits and CONTACT clicks in place.
CAUTION: Please note that track with fixtures may not be balanced and could pivot if flexible cable is used to suspend track stick. Utilizing stiff stem mounting system will ensure track is aligned properly.
Lightolier adapter
Halo adapter
Juno adapter
Signify Holding. All rights reserved. This document may be subject to change.
No representation or warranty as to the accuracy or completeness of the
information included herein is given and any liability for any action in
reliance thereon is disclaimed. All trademarks are owned by Signify Holding or
their respective owners.
Signify North America Corporation
200 Franklin Square Drive,
Somerset, NJ 08873
Telephone 855-486-2216
Signify Canada Ltd.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Telephone 800-668-9008