NJOY 20C06 Floor Fan Instruction Manual
- June 5, 2024
- NJOY
Table of Contents
NJOY 20C06 Floor Fan
overview
Warning: Never insert the plug into the wall socket when the fan is disassembled, this can cause an electrical hazard. Read and keep this manual before using the product.
Safety instructions
- Connect the device to an earthed socket with an agreed voltage as stated on the device.
- Only use the fan as described in this manual.
- This product is suitable for domestic use only
- This product is not suitable for outdoor, commercial or industrial use.
- Never immerse this product in water or any other liquid.
- Do not spray liquids over the fan
- Do not cover this product
- Do not place this device in a damp room or next to a sink.
- Do not use this product in the presence of explosive and/or flammable vapours
- Never place this product or any part of it near open fire or other heat sources.
- Place this product out of the reach of children
- Always place this product on a stable surface
- Remove all objects in the immediate vicinity of this product so that the swivel mechanism is not obstructed.
- Never insert anything through the fan grille and supervise when the fan is switched on.
- Do not place that product near an open window
- This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they are supervised by someone responsible for their safety or have been instructed in the use of the device.
THE POWER PLUG SHALL BE DISCONNECTED FROM THE MAINS SUPPLY
- When the fan is not in use
- When it is moved
- When servicing the fan
- When cleaning the fan
DO NOT USE THE FAN
- When the plug or cord is damaged
- When the fan has fallen
- When the fan is not working properly
- If the fan is damaged in any way
Do not hang this product on a wall or ceiling. Do not operate this product if the fan grilles are not correctly in place. If the cord is damaged, have it replaced by a qualified electrician.
ASSEMBLING INSTRUCTIONS
- Remove the packaging material from the fan control box.
- Combine the two base tubes (3) with a screw (5), into a complete stand.
- Place the spacers on the mounting screws on the two extremities of the fan body.
- Insert the base tube on the mounting screws.
- Tighten the outer nuts to the fan base.
NOTE: When installing the fan, make sure that the cables are outside the base
INSTRUCTIONS FOR USE
Check that the fan is placed on a solid and level surface.
THE FAN HAS THE FOLLOWING CONTROLS
- 0 = Off
- 1 = Quiet soft breeze
- 2 = Normal speed
- 3 = Maximum speed
MAINTENANCE AND CLEANING
BE THE FIRST TO UNPLUG THE POWER CORD FROM THE WALL SOCKET. Only use the fan in a dry clean room to minimize contamination. Remove dirt with a damp cloth. Do not use aggressive cleaning agents If the fan is disassembled, make sure that it is reassembled according to these operating instructions. NEVER plug the power plug into the wall socket when the fan is disassembled.
THE ENVIRONMENT
When this product reaches the end of its service life, return it to a collection point for reuse of electrical and electronic equipment. Pay attention to the references and symbols on the product, in the instruction manual or on the packaging. Contact your local authority for the address of the appropriate collection point in your area.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>