Polybird P-30 2 Inch Glider Chair Instruction Manual
- June 1, 2024
- Polybird
Table of Contents
Polybird P-30 2 Inch Glider Chair
TOOLS
HARDWARE
PARTS
Installation Instructions
Note before starting: wait until the whole piece is assembled to tighten the bolts completely.
- Attach seat (B) to legs C and D using four 1/4” x 2 1/4” wafer bolts (AA), one for each front leg and one for each top hole in the back legs, working from the outside in. Then use two 1/4” x 1 3/4” wafer bolts (EE), one for each bottom hole in the back legs. Add a 1/4” flange nut (GG) to each bolt, as shown.
- Attach seat back (A) to the assembly from step 1 by inserting four 2 1/2” screws (CC) through the back brace at the seat. Then insert six 1” screws (BB) under the armrests.
- Assemble the glider base. Attach base pieces G & H to F & E using three 1 1/2” screws (FF) in each corner, as shown.
- Lift chair assembly from step 2 over base assembly from step 3. Attach chair to base working from the outside in: Insert a 5/16” x 2 1/2” wafer bolt (DD) through leg and then through metal support on base, finish with a lock nut (HH). Repeat for each of the 4 corners of the chair.
Note before starting: wait until the whole piece is assembled to tighten the bolts completely.
FAQ
Q: Do I need my own tools for assembly?
A: Yes, you will need a screwdriver, which is not provided. A wrench and hex key are required but not specified if included.
Q: Should I fully tighten the bolts as I assemble each part?
A: No, you should wait until the entire chair is assembled before fully tightening all bolts.
Q: How many steps are there in the assembly process?
A: There are four main steps in the assembly process.
Q: What should I do if I have extra hardware after assembly?
A: Verify each step to ensure all hardware has been used correctly. If there is still extra hardware, please review the instructions again or contact the manufacturer.
We hope you enjoy your new piece of furniture for years to come!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>