Beijing Kingsmith WPACC2 WalkingPad User Manual
- June 16, 2024
- Beijing Kingsmith
Table of Contents
WPACC2 WalkingPad User Manual
Remote controller
How to use the remote controller
The remote controller and the WalkingPad are pre-pairec before delivery by default If the remote controller does not work or you change a new remote controller, please re-pair by pressing anc holding the Mode Switch button or the remote controller while turning on the WalkingPad. When you hear a “beep” sound, it proves a successful pairing.
Press the Start/Stop button while the machine in switched on.
After a 3-seconc countdown, the machine starts running slowly at 1 km/h by
default.
Press + while the machine is running.
The speed switches among 1/1.5/2/2.5/3/3.5/4/4.5/5/5.5/€ km/h.
Press – while the machine is running.
The speed switches among 6/5.5/5/4.5/4/3.5/3/2.5/2/1.5/1 km/h.
Press the Start/Stop button while the machine is running.
The machine slowly speeds dowr anc pauses. Then if no-loao operation lasts for
10 minutes,the machine stops anc enters Sleep mode.
Press and hold the Mode Switch button when the machine pauses.
The machine sleeps. To wake up the machine press any button on the remote
controller.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a articular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
IC STATEMENT
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>