Furfluffs T38300 Kitten User Manual

June 9, 2024
Furfluffs

FLUFF MODE

3xAA (LR6)1.5V

Furfluffs T38300 Kitten A01

PET MODE
 [

Furfluffs T38300 Kitten QR 1](https://qrco.de/bcr6jy) INSTRUCTIONAL VIDEOS!

www.FurFlus.com

WWW.SPINMASTER.COM CUSTOMERCARE@SPINMASTER.COM

ON/LOW VOLUME/OFF

ON / ON                                            I
LOW VOLUME
OFF / OFF                                        O

Furfluffs T38300 Kitten A02

When you first get your FUR FLUFFS home:

1. Switch it OFF
2. Change the batteries
3. Switch it to ON
4. Middle position is a LOW VOLUME setting

INSTALLING BATTERIES

FLUFF MODE

BONDING

Furfluffs T38300 Kitten C01a

AFTER BONDING

TAP BACK

Furfluffs T38300 Kitten D03

PET MODE

Furfluffs T38300 Kitten D04a

Furfluffs T38300 Kitten D05 Furfluffs T38300
Kitten D06

MUSIC MODE

Furfluffs T38300 Kitten D09 Furfluffs T38300
Kitten D10

SLEEP

INSTALLING BATTERIES
  1. Uncover the battery compartment by opening the flap on the bottom of your FUR FLUFFS.
  2. Open the battery door with a screwdriver. Remove used batteries by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
  3. Install new batteries as shown in the polarity diagram (+/-).
  4. Replace battery door. Check your local laws and regulations for correct recycling and/or battery disposal.

Note: Batteries included are for in-store demonstration and should be replaced to improve performance.

LOW BATTERY WARNING:

When your FUR FLUFFS has low batteries, they will beep three times and fall asleep.
If this is happening repeatedly, it is time to change the batteries.

BONDING
  1. Once you bring your FUR FLUFFS home, you first need to BOND with them to coax them out of hiding. Play with your FUR FLUFFS to bond:
    A. PET / B. PLACE UPSIDE DOWN / C. SHAKE / D. TOSS

  2. As your FLUFF gets more comfortable with you, they will reveal their ears to you.

  3. You know they are getting close to PET MODE when they peek out at you.

  4. Keep playing until you hear the music and your FLUFF will transform into a PET.

  5. Now your FUR FLUFFS will move back and forth between FLUFF and PET.

AFTER BONDING

Once you have bonded with your FUR FLUFFS, there are even more ways to play:

1. TICKLE – use quick touches on your FUR FLUFFS’s head to tickle them.
2. COLD – If your FLUFF is cold and shivering, warm them up by touching and holding the top of their head.

TAP BACK

You can play a TAP BACK game in FLUFF mode.

  1. TILT your FLUFF side to side. You’ll hear “Bop, Bop, Bop”.
  2. Your FLUFF’s ears pop up when they enter TAP BACK and are listening. Place them down on a flat surface.
  3. TAP a pattern on your FLUFF’s forehead and they will “BOP” the pattern back to you.
  4. Tap too fast or too many times, your FLUFF might get confused. They’ll make a confused sound, close their ears and go back to FLUFF mode.
  5. To exit TAP BACK, toss your FLUFF in the air.
FLUFF TO PET

To go from FLUFF to PET, you can PET, TICKLE, TOSS, SHAKE or PLACE UPSIDE DOWN.
Just pick which one you want to do and repeat the action a few times, until your FLUFF opens up to PET
The fastest way is to PLACE them UPSIDE DOWN and let them do a somersault.

PET MODE

To play in PET MODE:

  1. PET your FUR FLUFFS’s head between their ears to make them coo and purr. Pet them long enough and you can lull them back into FLUFF mode.

  2. TICKLE your PET’s head between the ears with quick touches, to make them wiggle and giggle.

  3. TOSS your PET in the air to play with them. Toss them too high and you might scare them back into FLUFF mode.

  4. Turn your PET UPSIDE DOWN , wait for their ears to close, then place them on their head. They’ll try and somersault themselves back onto their feet! (DO NOT push their ears closed)

  5. Give your PET a SHAKE and they will shake back! Shake too much and you might get a funny response.

  6. TILT your PET forward to feed them. You’ll hear lots of munching. If they eat too much they might get gassy or get the hiccups!

  7. If your PET is GASSY, you can pat their head between the ears to burp them (A), or tilt them upside down to make them fart (B).

  8. HICCUPS – If your FUR FLUFFS gets the hiccups (A), you can scare their hiccups away! Wait until they’re quiet between hiccups, then bang on the table beside them to scare them (B)!
    They’ll close back up into FLUFF mode (C).

  9. SCARING your PET sends them back to FLUFF mode. Pet your FLUFF’s head between the ears to calm them down.

  10. SNEEZE – If your FUR FLUFFS starts to sneeze going “Ah, Ah, Ah”, touch and hold their head between the ears to pause their sneeze before the “Choo!”

PET TO FLUFF

To go from PET to FLUFF, you can PET their head or SCARE them.
The fastest way is to TOSS your PET up high and scare them back to FLUFF.

MUSIC MODE

You can enter MUSIC mode by tilting your PET, from side to side. (You cannot enter MUSIC mode from FLUFF mode)
Tilt 4 times; Left, Right, Left, Right (A) Your PET will count you in, then start playing music and dancing! (B)

WHILE IN MUSIC MODE:

TOUCH your PET’s head between the ears (C) – They stop dancing and start singing along instead! (D)
WHILE YOUR PET IS SINGING:

  1. SHAKE your PET – Their voice will warble
  2. TOSS your PET into the air – They’ll sing a high note
  3. TILT your PET left and right – They’ll play a funny note.
  4. TOUCH your PET’s head between the ears to return to dancing
  5. TO EXIT MUSIC MODE , turn your PET upside down until you hear a record scratch.
SLEEP

If you do not play with your FUR FLUFFS for a while, they will fall asleep and enter Low Power Sleep Mode.
To wake your FUR FLUFFS up, wait until they’ve fallen deep asleep and haven’t made any sound for 2 seconds. Then, you can TILT, TOSS or SHAKE them to wake them up.
For TROUBLESHOOTING questions and solutions, please visit our website:
www.FurFluffs.com

CARE AND MAINTENANCE: Always remove batteries from the toy when it is not being used for a long period of time. Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat. Do not submerge the toy in water. This can damage the electronic assemblies.

BATTERY SAFETY INFORMATION: Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable-rechargeable batteries are to be removed from the toy before being charged. DO NOT recharge non- rechargeable batteries. DO NOT short-circuit the supply terminals.

Safety Precautions: – Remove batteries when not in use. – Parental guidance is recommended for the play. -New alkaline batteries are recommended to obtain maximum performance.

Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.

NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

FCC STATEMENT: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:
• Reorient or relocate the receiving antenna
• Increase the separation between the toy and the radio or the TV
• Consult the dealer or an experienced TV-radio technician for help.

NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party please visit fcc.spinmaster.com

Requires 3 x AA 1.5 V (LR6) batteries (included). Batteries or battery packs must be removed for recycling and proper disposal. When this product has reached the end of its useful life, it should not be disposed of with other household waste. EU legislation for Electrical and Electronic Equipment and Batteries, requires these to be separately collected so that they can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.

Do not change or modify anything on the toy.
Spin Master Ltd. reserves the right to discontinue the FurFluffs.com website at any time.
Before first use: Read the user’s information together with your child.
Retain this information, addresses and phone numbers for future reference.

WARNING: CHOKING HAZARD – Small parts. Not suitable for children under three years.


PATENT INFORMATION:PATENTS.SPINMASTER.COM

Spin Master Logo & (c) Spin Master Ltd. All Rights Reserved.

NORTH AMERICA
1-800-622-8339, customercare@spinmaster.com

UK – 0800 206 1191, serviceuk@spinmaster.com
IRELAND – 1800 992 249
FRANCE – 0800 909 150, servicefr@spinmaster.com
AUSTRALIA – 1800 316 982, customercare@spinmaster.com
DEUTSCHLAND – 00800 0101 0222, Kundenservice@spinmaster.com
SCHWEIZ – 0800 561 350 • OSTERREICH – 0800 297 267
NEDERLAND – 0800 022 3683, klantenservice@spinmaster.com
BELGIQUE – 0800 77 688 • LUXEMBOURG – 800 2 8044
ITALIA – 800 788 532, servizio@spinmaster.com MÉXICO – 800 9530147, servicio@spinmaster.com
POLSKA – 800080238, poland@spinmaster.com ČESKÁ REPUBLIKA – 800550530, czechrepublic@spinmaster.com
SLOVENSKO – 0800232800, slovakia@spinmaster.com MAGYARORSZÁG – 080 100 052, hungary@spinmaster.com
ROMANIA – 0800400015, romania@spinmaster.com
RUSSIA – 88003013822, russia@spinmaster.com

©2022.TM & © SPIN MASTER LTD. ALL RIGHTS RESERVED./TOUS DROITS RÉSERVÉS.
SPIN MASTER LTD., 225 KING STREET WEST, TORONTO ON M5V 3M2 CANADA
SPIN MASTER INC., PMB #10053, 300 INTERNATIONAL DRIVE, SUITE 100, WILLIAMSVILLE, NY 14221
SPIN MASTER INTERNATIONAL B.V., KINGSFORDWEG 151, 1043 GR AMSTERDAM, NL
SPIN MASTER AUSTRALIA PTY LTD, SUITE 101, LEVEL 1, 18-24 CHANDOS STREET,
ST LEONARDS, NSW 2065; 1800 316 982 • SPIN MASTER TOYS UK LTD.
BOSTON HOUSE, BOSTON DRIVE, BOURNE END, BUCKINGHAMSHIRE, SL8 5YS, UK

MADE IN CHINA

T38300_0005_20139110_GML_IS_R1

Country of Origin – Placement

Factory according to production country to print Country of Origin (COO)
If corresponding country is not in below, contact Spin Master to provide translation

China        MADE IN CHINA
Mexico     MADE IN MEXICO
Vietnam    MADE IN VIETNAM
India         MADE IN INDIA

Country of Origin Placement

Documents / Resources

| Furfluffs T38300 Kitten [pdf] User Manual
T38300 Kitten, T38300, Kitten
---|---

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals