Bellevue MVLCH78719MBK Rodney 5 Light 24 Wide Taper Candle Chandelier Instruction Manual
- June 1, 2024
- BELLEVUE
Table of Contents
MVLCH78719MBK Rodney 5 Light 24 Wide
Taper Candle Chandelier
Instruction Manual
PACKAGE CONTENTS
| PART | DESCRIPTION | QUANTITY |
|---|---|---|
| A | Crossbar Assembly | 1pc |
| B | Wire Connector | 3pcs |
| C | Outlet Box Screw | 2pcs |
| D | Quick Link | 2pcs |
| E | Ceiling Canopy | 1pc |
| F | Fixture Chain | 1pc |
| G | Arm Assembly | 1pe |
| H | Arm | 2pcs |
| I | Socket Assembly | 1pc |
| J | Lock Screw (Pre-assembled to socket assembly) | 6pcs |
If the ceiling canopy
is not snug against the ceiling, remove it rom the crossbar assembly. Adjust
the length of the pre-assembled nipple by unscrewing the pre-assembled hex
nut. Screw the nipple in or out of the crossbar until the correct length is
achieved. Then, re-attach the ceiling canopy.
A. Adjust fixture chain length.
B. – C Install Fixture Chain
‘Suggested Chain Length:
8’ ceiling: 10″ Chain
9’ ceiling: 22″ Chain
10’ ceiling: 34″ Chain
11’ ceiling: 46” Chain
12’ ceiling: 58” Chain
A – Pull the supply wires and ground wire up through the fixture chain
alternating links.
B – Push the ends of the supply wires and ground wire up through the loop and
into the outlet box.
C – Remove the canopy.
D – Push The remaining slack wire into the outlet box.
Trim excess fixture wire leaving a minimum of 6 inches hanging out of the
outlet box.
Separate the smooth side and ribbed side of supply wire.
Using wire strippers, strip each wire 1/2 inch from the end.
CARE AND MAINTENANCE
- Wipe clean using soft, dry cloth or static duster. Always avoid using harsh chemicals and abrasives to clean fixture as they may damage the finish.
TROUBLESHOOTING
| PROBLEM | POSSIBLE CAUSE | CORRECTIVE ACTION |
|---|---|---|
| Bulbs will not light. | 1. Bulb is burned out. |
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.| 1. Replace light bulb.
2. Make sure power supply is on.
3. Check wiring.
4. Test or replace the switch.
Fuse blows or the circuit breaker trips
when light is turned on.| Crossed wires or power wire is grounding out.| Check
wire connection.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>