BELLEVUE MVLCF49394BN Salmantica 12 Wide Semi Flush Ceiling Fixture Instruction Manual

BELLEVUE MVLCF49394BN Salmantica 12 Wide Semi Flush Ceiling Fixture

Warnings And Cautions

• Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
• These instructions are provided for your safety. You must read them completely before installing the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
• Disconnect fixture from power source before replacing the bulbs.
  • Make sure bulbs are given sufficient time to cool before removal.
  • Do not subject glass parts to any shock while in operation or shattering may result.

Package Contents

Tools Required (not included): Flathead screwdriver, Phillips screwdriver, Electrical tape, Safety goggles, Ladder.
Bulb Recommended: (1) 60W Type-S medium base vintage-style bulb, Alternate (1) LED bulb.
Estimated Assembly Time: 20 – 30 minutes

Preparation:

• Identify and inspect all parts before beginning installation
• Check package contents list and diagrams below to be sure all parts are included .
• If any parts are missing or damaged, do not attempt to assemble, install or operate the fixture.

INSTALLATION INSTRUCTION

• STEP 1:

  • a. Remove the crossbar from the ceiling canopy on the fixture body.
  • b. Secure the crossbar to the outlet box (not included) with outlet box screws.
  • c. Tighten until snug.
    Note: The tab on the crossbar should protrude outward.

• STEP 2:

  • a. The lanyard is provided as a means to support the fixture from the junction box while connecting the electrical wires. This enables the fixture to hang from the junction box and your hands are free to make the wire connections.
  • b. Turn the button stop so it may be inserted into the crossbar slot. Make sure the button stop is completely inside the crossbar.
  • c. Slowly release the fixture to make sure it is supported by the button stop.
  • d. Proceed to Step 4. Once wiring is complete, the lanyard will push into the junction box when the Ceiling Canopy is Attached to the ceiling.

• STEP 3:

• Use Wire Connectors (supplied) to connect the wires.

  • a) Ground Wire:
  1. Wrap supply ground wire around green ground screw on mounting bracket, no less than 2 in. from the end of the wire. Tighten ground screw.
  2. Connect fixture ground wire to supply ground wire with wire connector.
  • b) Supply Wire:
  1. Connect the supply white wire to the white fixture supply wire with wire connector.
  2. Connect the supply black (or red) wire to the black fixture supply wire with wire connector.
  3. Wrap each connection with approved electrical tape and carefully stuff all of the connected wires into the outlet box.

• STEP 4:

  • a. Line up the holes on the canopy of the fixture body and the mounting holes on the crossbar.
  • b. Secure with the mounting screws. Tighten until snug.

• STEP 5:

  • a. Remove the socket collar from the socket on the fixture body.
  • b. T hen place the shade over the socket on the fixture body as shown.
  • c. Secure by threading the socket collar onto the socket.
  • d. Hand-tighten until snug.

• STEP 6:

  • a. Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
    Your installation is completed now. Restore electricity. Retain this sheet for future reference.

CARE AND MAINTENANCE

Wipe clean using soft, dry cloth or static duster. Always avoid using harsh chemicals and abrasives to clean fixture as they may damage the finish.

TROUBLESHOOTING

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>