HD Ridez WB-TR298BD Overland Slider Drop Steps Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-TR298BD Overland Slider Drop Steps
PARTS LIST
PROCEDURE
-
REMOVE CONTENTS FROM THE BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. USE ILLUSTRATION TO IDENTIFY BRACKETS AND RUNNING BOARDS.
-
Start installation on the Driver/Left front of the vehicle, and remove the plastic plugs or hex bolts covering the (2) threaded holes in the body panel, (Figure 1).
-
Select the Driver/Left Front Mounting Bracket, (Figure 2). Attach the Bracket to the vehicle using the included (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers. Do not tighten the hardware.
-
Next, move to the 2nd, 3rd, and 4th mounting locations (Figure 3 – 5). Select the Driver/Left Rear Mounting Bracket, (Figure 6).
-
Select the Driver/Left Main Tube.
IMPORTANT: Use the illustration above to help identify the correct Main Tube. Insert (2) 8mm Bolt Plates into the front (2) sets of (2) holes, (Figure 7). Attach (1) Drop Step to the (2) Bolt Plates with (4) 8mm x 22mm Flat Washers and (4) 8mm Nylon Lock Nuts, (Figure -
Do not tighten the hardware.
-
With assistance, line up the holes in the mounting tabs on the Running Board to the rear-facing slots in the Mounting Brackets.
-
Attach the Driver/Left Main Tube to the Mounting Brackets with (8) 10mm Hex Bolts, (16) 10mm Flat Washers and (8) 10mm Nylon Lock Nuts, (Figure 9). Do not tighten the hardware.
-
Level and adjust the Driver/Left Main Tube and tighten all hardware. 7. Repeat Steps 2—5 for Passenger/Right Main Tube.
-
Do periodic inspections of the installation to make sure that all hardware is secure and tight.
To protect your investment
Do not use any type of polish or wax that may contain abrasives that could
damage the finish. Mild soap may be used to clean Slider Drop Step.
Driver/left Side Installation Pictured
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>