hygger HG-963 Aquarium Truck Bubble Light Decoration User Manual
- June 3, 2024
- hygger
Table of Contents
hygger HG-963 Aquarium Truck Bubble Light Decoration
The Hygger Aquarium Trunk Bubble Decoration runs via an air pump which not only produces constant bubbles to oxygenate your aquarium water but also includes a colorful LED spotlight to add the beautiful effect of overflowing lava! It allows fish to shuttle freely among the trunk, adding a natural look to the fish tank.
PRODUCT FEATURES
Bright LED: Energy efficient and reliable long-lasting LED lights add brightness and color to the aquarium.
Agitates water: The air stone produces a constant stream of bubbles which helps oxygenate aquarium water.
Waterproof: Level IP68 Waterproof ensures long lasting use.
Safety: The light has the advantage of long life-span and increased safety due to its low, 5v voltage transformer.
Beautiful Design: The Hygger Aquarium Trunk Bubble Decoration changes your aquarium into a beautiful scenery.
PRODUCT SPECS
| Temperature | 32-104°F |
|---|---|
| Input Voltage | 100-240V |
| Frequency | 50/60Hz |
| Power | 1.2W |
| LED quantity | 6 PCS |
| Air Tube | 4 mm (3/16 Inch) |
| --- | --- |
| Air Tube length | 4.9FT |
| Cord length | 9.5FT |
| Depth | 3FT |
METHOD OF APPLICATION
- Soak the bubble light decoration for 10-15 minutes in water before first use.
- Ensure the bubble light is clipped into the hole.
- Join the air tube to the outlet of the air pump.
- Place the bubble light in the desired location in your aquarium.
- 5.Clip the wire and the air tube into the slot.
- Place the air pump higher than the water level of the tank.
- Plug in the bubble light decoration and the air pump.
ATTENTION!
- Working voltage must be compatible with the prescribed voltage of the transformer.
- The transformers are not waterproof! Keep them away from water.
- Do not touch the transformer with wet hands.
- Check the working voltage and power when this product isn’t work normally.
- Air pump must be placed higher than the water level of the tank, or equipped another check valve on the air tube to prevent back-flow when the power is off.
WARNING
- To avoid possible electric shock, special care should be For each of the following situations, do not attempt to repair yourself; return the product to an authorized service facility for service, or discard the light.
- If the transformer connector falls into the water, do not touch it! First unplug it, then retrieve it.
- Carefully examine the product after It should not be plugged in if there is water on parts not intended to be wet.
- Do not operate the product if it has a damaged cord or plug, if it is malfunctioning, or if it is dropped or damaged in any manner. The power cord of this product cannot be replaced; if the cord is damaged, the product should be discarded.
- To avoid the possibility of the product plug getting wet, position thew aquarium stand and tank to one side of a wall mounted power outlet to prevent water from dripping onto the outlet or plug. A”drip loop”, shown in the figure below, should be arranged by the user for each cord connecting the product to the outlet. The “drip loop” is the part of the cord below the level of the outlet, or the connector. If an extension cord is used, use a drip loop prevent water traveling along the cord and coming in contact with the outlet. If the plug or outlet does get wet, DO NOT unplug the cord. Disconnect the fuse to the circuit breaker that supplies power to the product. Then, unplug and examine for the presence of water in the outlet. If you are unsure, consult a certified electrician.
- Close supervision is necessary when the light is used near
- Always unplug the product from the outlet when not in use, before putting on or taking off parts, and before maintenance or placing hands in the water. Never yank the cord to pull plug from outlet. Grasp the plug and pull gently to disconnect.
- Do not use the light decoration for other than its intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.
- Do not install or store the product where it will be exposed to weather or to temperatures below 32° This product on is suitable for use in water temperatures less than 104°F.
- Make sure the product is securely installed before operating 7.Read and observe all the important notices for this product.
- lf an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may Care should be taken to arrange the cord so that it will not be tripped over or pulled.
- The light is intended FOR HOUSEHOLD USE
TROUBLE SHOOTING
- Air flow attenuation (decrease)
- Make sure the air tube is not bent, clogged or damaged
- Make sure the power supply is working
- Clean the air intake
- Clean the surface of the stone
- The adapter is broken
- The light doesn’t work
- Checking the working voltage and power supply
PACKAGE INCLUDED
- 1 x Led bubble light
- 1 x Adaptor
- 1 x PVC tube
- 1 x User manual
WARRANTY
- 1-year limited warranty.
- 1-month free return.
- Free replacement for 3 months.
DISPOSAL
Do not dispose this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary. This product must not be disposed together with domestic waste. This product has to be disposed at an authorized place for the recycling of electrical and electronic appliances. By collecting and recycling waste, you help save natural resources, and make sure the product is disposed in an environmentally friendly way!
Contact information
Website: www.hygger-online.com
E-mail: mago@hygger-online.com
Thank you for choosing Hygger, making aquarium keeping easier one product at a time.
If you have any problems or suggestions for the aquarium extendable led light, please contact us by email before leaving feedback or opening a case, it will be the fastest way to solve your problem. If you are satisfied with the aquarium extendable led light, please leave positive feedback for our product, in order to let more customers enjoy it. Thanks again!
Brand owner: Shenzhen Mago Trading Co., Ltd
Add: Bantian Group Business Central, Longgang District, Shenzhen City, Guangdong Province, China
E-mail: mago@hygger-online.com
Website: http://www.hygger-online.com
Facebook: https://www.facebook.com/shenzhenmago
Or @shenzhenmago
Documents / Resources
|
hygger HG-963 Aquarium Truck Bubble Light
Decoration
[pdf] User Manual
HG-963 Aquarium Truck Bubble Light Decoration, HG-963, HG-963 Aquarium Truck
Bubble Light, Aquarium Truck Bubble Light Decoration, Aquarium Truck Bubble
Light, Aquarium Bubble Light, Bubble Light, Aquarium Light, Truck Bubble Light
Decoration, Truck Light Decoration, Bubble Light Decoration, Light Decoration,
Aquarium Light Decoration
---|---