iOttie VLXWCG212 Velox Qi2 Dash User Guide
- June 1, 2024
- iOttie
Table of Contents
Quick Start Guide
Velox Mini Qi2 Magnetic Wireless Charger
Dash & Windshield Mount
Product Assembly
(1)
Connect the mount cradle to the ball joint.
(2)
Tighten the cradle knob.
Connect the USB-C cable to your vehicle’s USB-C port outlet via the included power adapter.
! If using a phone case, ensure it is Qi2 or MagSafe compatible not properly attach or charge.
Product Installation
A. Dashboard Mounting
(1)
Choose a flat mounting location on your dashboard and wipe the surface clean. Peel off the film on the dashboard pad and evenly press onto the desired location. Wait 20 minutes.
(2)
Remove the plastic cover from the suction cup and firmly press onto the dashboard pad. Push the lever down to engage suction.
Do not install on leather dashboards.
B. Windshield Mounting
Choose a mounting location on your windshield and wipe the surface clean. Remove the plastic cover from the suction cup and firmly press onto the windshield. Push the lever down to engage suction.
Do not use the dashboard pad when mounting on the windshield.
Please Note
Your phone has overheating protection. To prevent overheating, keep the cradle below the dashboard, out of direct sunlight, and lower screen brightness.
0i2-CERTIFIED & MAGSAFE COMPATIBLE
Only compatible with Qi2-enabled devices and MagSafe series iPhones and cases.
Scan OR code for full manual & product registration
http://www.iottie.com/qr-code?sku=VLXWCG213
Declaration of Conformity (FCC)
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
You can refer to the following completed FCC warnings.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. This
equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 15cm
between the radiator & your body.
IC warning statements:
Warning Statement:
RSS-GEN ISSUE 5, 8.4 User manual notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that are deemed to comply without testing of specifc absorption ratio (SAR).
This equipment should be installed and operated with minimum distance 0cm between the radiator & your body.
Follow @iottie for the latest news and updates!
Please visit our website for more information.
www.iottie.com
HELLO !
Thanks you for your purchase.
Take 15% Off
Your next order at iottie.com with code:
THANKYOU15
If you’re happy with your purchase. please leave us a review on Amazon!
If you are unsatisfied for any reason, please reach out to our support team at cs@iottie.com
Rethinking
Packaging
100% recyclable and plastic-free
Reduced packaging size
Printed with soy ink
Learn more at iottie.com/about-us/sustainability
Declaration of Conformity (FCC)
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
You can refer to the following completed FCC warnings.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference
that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>